8/16 PS/2 KVM over IP switch
1. The Quick Installation Guide
Installation
PS/2 IP-KVM switch redirects local keyboard, mouse and video data to a remote administration console. All data is transmitted via IP. PS/2 IP-KVM switch can be used in a multi administrator and multi server environment as well. Besides, PS/2 IP-KVM switch is a KVM switch, which can also be used with a local console. Connecting PS/2 IP-KVM switch to the host system
In order to connect the PS/2 IP-KVM switch perform the following steps:
1.Connect the power supply to PS/2 IP-KVM switch.
2.Connect the monitor to the PS/2 IP-KVM switch.
3.Connect the keyboard to the PS/2 IP-KVM switch.
4.Connect the mouse to the PS/2 IP-KVM switch.
5.Plug the HDDB15 pin connector of a 3-in-one cable into any label computer port on the rear of PS/2 IP-KVM switch unit. Then connect the HDDB-15 pin male type for PC video, the purple Mini Din 6 pin female type for keyboard and the green Mini Din 6 pin female type for mouse. To plug these three connectors into the respective ports of computer.
6.Repeat item 5 procedure to all of PC ports of PS/2 IP-KVM switch
7.Connect Ethernet and/or modem, depending how you want to access PS/2 IP-KVM switch.
Video modes
PS/2 IP-KVM switch recognizes a limited number of common video modes. When running X-Window on the host system, please don’t use any custom mode lines with special video modes. If done so, PS/2 IP-KVM SWITCH may not be able to detect these. You are on the safe side with all standard VESA video modes. Please refer to Appendix C for a list of all known modes.
Initial IP configuration
Initially the PS/2 IP-KVM switch network interface is configured with the parameters shown in Table 1.1.
Parameter | Value |
IP auto configuration | DHCP |
IP-Address | 192.168.1.22 |
Net-mask | 255.255.255.0 |
Default-Gateway | none |
Table 1.1: Initial configuration
If this initial configuration doesn’t meet your local requirements, you need to do the initial IP configuration. Use one of the following ways:
1.Connect the enclosed NULL modem cable to the serial interface on the rear side. The serial interface needs to be adjusted with the parameters shown in table 1.2:
Parameter | Value |
Bits/second | 115200 |
Data bits | 8 |
Parity | No |
Stop bits | 1 |
Flow Control | None |
Table 1.2: Serial parameters
