Atlantis Land A02-RAV211 manual For Windows NT4.0

Page 16

VoIP ROUTER ADSL

For Windows NT4.0

1.Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and choose the Protocols tab.

2.Select TCP/IP Protocol and click Properties.

3.Select the Obtain an IP address from a DHCP server radio button and click “OK”.

10

Image 16

Contents VoIP Router Adsl Page Copyright CE Mark WarningImportant Note FCC WarningTable of Contents Chapter Chapter Page Introduction An Overview of the VoIP Router AdslPackage Contents VoIP Router Adsl FeaturesPage VoIP Router Adsl Application Front LEDs Rear PortsCabling Before Configuration Connecting the VoIP Router AdslConfiguring PC in Windows For Windows 95/98/MEVoIP Router Adsl For Windows NT4.0 For Windows Click OK to finish the configuration For Windows XP VoIP Router Adsl Factory Default Settings Username and PasswordConfiguring with the Web Browser Information from the ISPStatus Quick StartStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP StatusStatus- PPP Status Status- Learned MAC TableRouting Table System LogQuick Start Security LogsAdsl Quick Start VoIP Quick Start ConfigurationVoIP System Firewall Virtual Server Advanced 3.1 WAN VoIP Router Adsl Static IP Settings Service Category Select UBR or CBR Dhcp ClientMAC Spoofing 3.2 LAN Device IP Address Dhcp ServerVoIP VoIP Router Adsl AuthorizationUserID Same as UserID Phone Book CallWaiting Enable/Disable the call waiting feature Call FeatureCallForwarding Advanced Telephony Settings CallReturn Enable/Disable the call return featureConfigure Caller ID info Echo Cancellation Tail Length Setting the Tail Length Ring & Tone Configuration Timeouts System Password Time ZoneFactory Setting UpgradeRestart Firewall Packet FilteringVoIP Router Adsl Bridge Filtering Intrusion DetectionBlock WAN Request Virtual Server AdvancedAdsl 3.7.2 DNSDynamic DNS 3.7.4 NAT VoIP Router Adsl RIP Default is Disabled Border Gateway Default is Enabled 3.7.5 RIPStatic Route Misc Configuration Dhcp Relay Default at Dhcp Server Dhcp Target IP Default isDiagnostic Test Igmp Proxy Default at DisabledTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM Segment Loop Back Test ATM OAM End-to-End Loop BackTest Ethernet connect to ATM Test IP connect to PPPSave Config Test Internet connectionProblems with the LAN Interface Problems with the WAN InterfaceProblem Corrective Action Technical Features Appendix B Support