Atlantis Land A02-RAV211 manual Cabling

Page 12

VoIP ROUTER ADSL

PORT

Meaning

Power Switch

A Power ON/OFF switch

 

 

Power Jack

Connect

the supplied

power

adapter to this

jack.

 

 

 

 

 

 

 

 

 

 

 

Reset

Press it

to restore

the

factory

default

setting

back.

 

 

 

 

 

 

 

 

 

 

 

VoIP

Connect

the RJ-11

cable to

this port

when

connecting to the phone set.

 

 

 

 

 

 

 

 

Connect the supplied Ethernet cable to this port

 

when connecting to a NIC (Network Interface

LAN

card) in PC.

 

 

 

 

 

 

 

 

 

 

(RJ-45 connector)

Connect an UTP Ethernet cable to this port

 

 

when connecting to a LAN such as an office or

 

home network.

 

 

 

 

 

 

 

 

 

 

 

2.4 Cabling

The most common problem is bad cabling or ADSL line. Make sure that all connected devices are turned on. On the front of the product is a bank of LEDs. As a first check, verify that the LAN Link and ADSL line LEDs are lit and SYS is blanking. If they are not, verify that you are using the proper cables.

6

Page 11 Page 13
Image 12
Page 11 Page 13
Contents VoIP Router Adsl Page Copyright CE Mark WarningImportant Note FCC WarningTable of Contents Chapter Chapter Page Introduction An Overview of the VoIP Router AdslPackage Contents VoIP Router Adsl FeaturesPage VoIP Router Adsl Application Front LEDs Rear PortsCabling Before Configuration Connecting the VoIP Router AdslConfiguring PC in Windows For Windows 95/98/MEVoIP Router Adsl For Windows NT4.0 For Windows Click OK to finish the configuration For Windows XP VoIP Router Adsl Factory Default Settings Username and PasswordConfiguring with the Web Browser Information from the ISPStatus Quick StartStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP StatusStatus- PPP Status Status- Learned MAC TableRouting Table System LogSecurity Logs Quick StartAdsl Quick Start Configuration VoIP Quick StartVoIP System Firewall Virtual Server Advanced 3.1 WAN VoIP Router Adsl Service Category Select UBR or CBR Dhcp Client Static IP SettingsMAC Spoofing 3.2 LAN Device IP Address Dhcp ServerVoIP VoIP Router Adsl AuthorizationUserID Same as UserID Phone Book Call Feature CallWaiting Enable/Disable the call waiting featureCallForwarding Advanced Telephony Settings CallReturn Enable/Disable the call return featureConfigure Caller ID info Echo Cancellation Tail Length Setting the Tail Length Ring & Tone Configuration Timeouts System Password Time ZoneUpgrade Factory SettingRestart Firewall Packet FilteringVoIP Router Adsl Bridge Filtering Intrusion DetectionBlock WAN Request Virtual Server AdvancedAdsl 3.7.2 DNSDynamic DNS 3.7.4 NAT VoIP Router Adsl RIP Default is Disabled Border Gateway Default is Enabled 3.7.5 RIPStatic Route Misc Configuration Dhcp Relay Default at Dhcp Server Dhcp Target IP Default isDiagnostic Test Igmp Proxy Default at DisabledTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM Segment Loop Back Test ATM OAM End-to-End Loop BackTest Ethernet connect to ATM Test IP connect to PPPSave Config Test Internet connectionProblems with the WAN Interface Problems with the LAN InterfaceProblem Corrective Action Technical Features Appendix B Support
Top Page Image Contents