Atlantis Land A02-RAV211 manual VoIP Router Adsl

Page 50

VoIP ROUTER ADSL

Outgoing	Incoming: Determine whether the rule is for outgoing packets or for incoming
packets.

Active: Choose “Yes” to enable the rule, or choose “No” to disable the rule.

Packet Type: Specify the packet type (TCP, UDP, ICMP or any) that the rule will be applied to.

Select TCP if you want to scope for the connection-based application service on the remote server using the port number. Or select UDP if you want to scope for the connectionless application service on the remote server using the port number.

Log: Choose “Yes” if you want to generate logs when the filer rule is applied to a packet.

Action When Matched: If any packet matches this filter rule, Forward or Drop this packet.

Source IP Address: Enter the incoming or outgoing packet’s source IP address(es).

Source Port: Check the TCP or UDP packet’s source port number(s).

Destination IP Address: Enter the incoming or outgoing packet’s destination IP address(es).

Destination Port: Check the TCP or UDP packet’s destination port number(s).

44

Image 50

Contents VoIP Router Adsl Page Important Note CopyrightCE Mark Warning FCC WarningTable of Contents Chapter Chapter Page Introduction An Overview of the VoIP Router AdslPackage Contents VoIP Router Adsl FeaturesPage VoIP Router Adsl Application Front LEDs Rear PortsCabling Before Configuration Connecting the VoIP Router AdslConfiguring PC in Windows For Windows 95/98/MEVoIP Router Adsl For Windows NT4.0 For Windows Click OK to finish the configuration For Windows XP VoIP Router Adsl Factory Default Settings Username and PasswordConfiguring with the Web Browser Information from the ISPStatus Quick StartStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP StatusStatus- PPP Status Status- Learned MAC TableRouting Table System LogAdsl Quick Start Security LogsQuick Start VoIP System Firewall Virtual Server Advanced ConfigurationVoIP Quick Start 3.1 WAN VoIP Router Adsl MAC Spoofing Service Category Select UBR or CBR Dhcp ClientStatic IP Settings 3.2 LAN Device IP Address Dhcp ServerVoIP VoIP Router Adsl AuthorizationUserID Same as UserID Phone Book CallForwarding Call FeatureCallWaiting Enable/Disable the call waiting feature Advanced Telephony Settings CallReturn Enable/Disable the call return featureConfigure Caller ID info Echo Cancellation Tail Length Setting the Tail Length Ring & Tone Configuration Timeouts System Password Time ZoneRestart UpgradeFactory Setting Firewall Packet FilteringVoIP Router Adsl Bridge Filtering Intrusion DetectionBlock WAN Request Virtual Server AdvancedAdsl 3.7.2 DNSDynamic DNS 3.7.4 NAT VoIP Router Adsl RIP Default is Disabled Border Gateway Default is Enabled 3.7.5 RIPStatic Route Misc Configuration Dhcp Relay Default at Dhcp Server Dhcp Target IP Default isTesting Ethernet LAN connection Diagnostic TestIgmp Proxy Default at Disabled Testing Adsl SynchronizationTest Ethernet connect to ATM Test ATM OAM Segment Loop BackTest ATM OAM End-to-End Loop Back Test IP connect to PPPSave Config Test Internet connectionProblem Corrective Action Problems with the WAN InterfaceProblems with the LAN Interface Technical Features Appendix B Support