Atlantis Land A02-RAV211 manual Test ATM OAM Segment Loop Back, Test ATM OAM End-to-End Loop Back

Page 62

VoIP ROUTER ADSL

If this test returns FAIL, please try the test again a few minutes after this test is completed. Since your DSL modem need a couple of seconds to a few minutes to establish the DSL connection depending on your phone line quality. If this test returns FAIL, make sure your phone line is connected to your DSL modem securely, and also check with your service provider to see if your service is activated.

If this test returns FAIL, all other tests will be skipped.

Checking Circuit 0 for Network Connection

Test ATM OAM Segment Loop Back

This test sends ATM OAM F5 Segment loop back request cells to the central office equipments through your DSL connection. This test will pass if response cell is received. Since your service provider might not support this test, your DSL modem could still work even if this test fails.

If this test fails consistently and your DSL modem seems not working, check to make sure the VPI and VCI are configured correctly.

This test returns FAIL if the DSL synchronization test failed.

Test ATM OAM End-to-End Loop Back

This test sends ATM OAM F5 End-to-End loop back request cells to the central office equipments through your DSL connection. This test returns PASS if response cell is received. Since your service provider might not support this test, your DSL modem could still work even if this test fails.

If this test return FAIL consistently and your DSL modem seems not working, check to make sure the VPI and VCI are configured correctly.

This test returns SKIPPED if the DSL synchronization test failed.

Test Ethernet connect to ATM

This test returns PASS if the ATM AAL5 module is loaded correctly in your DSL modem. If this test returns FAIL, an internal error has occurred.

This test returns SKIPPED if the DSL synchronization does not return PASS.

Test IP connect to PPP

This test returns PASS if your DSL modem has been assigned a valid IP address by your service provider through DHCP or your DSL modem is assigned a valid IP address statically.

If this test returns FAIL, run this test again a few minutes after this test is completed. If this test returns FAIL consistently and DHCP client is turned on in your DSL modem, check with your

56

Page 61 Page 63
Image 62
Page 61 Page 63
Contents VoIP Router Adsl Page Important Note CopyrightCE Mark Warning FCC WarningTable of Contents Chapter Chapter Page Introduction An Overview of the VoIP Router AdslPackage Contents VoIP Router Adsl FeaturesPage VoIP Router Adsl Application Front LEDs Rear PortsCabling Before Configuration Connecting the VoIP Router AdslConfiguring PC in Windows For Windows 95/98/MEVoIP Router Adsl For Windows NT4.0 For Windows Click OK to finish the configuration For Windows XP VoIP Router Adsl Factory Default Settings Username and PasswordConfiguring with the Web Browser Information from the ISPStatus Quick StartStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP StatusStatus- PPP Status Status- Learned MAC TableRouting Table System LogAdsl Quick Start Security LogsQuick Start VoIP System Firewall Virtual Server Advanced ConfigurationVoIP Quick Start 3.1 WAN VoIP Router Adsl MAC Spoofing Service Category Select UBR or CBR Dhcp ClientStatic IP Settings 3.2 LAN Device IP Address Dhcp ServerVoIP VoIP Router Adsl AuthorizationUserID Same as UserID Phone Book CallForwarding Call FeatureCallWaiting Enable/Disable the call waiting feature Advanced Telephony Settings CallReturn Enable/Disable the call return featureConfigure Caller ID info Echo Cancellation Tail Length Setting the Tail Length Ring & Tone Configuration Timeouts System Password Time ZoneRestart UpgradeFactory Setting Firewall Packet FilteringVoIP Router Adsl Bridge Filtering Intrusion DetectionBlock WAN Request Virtual Server AdvancedAdsl 3.7.2 DNSDynamic DNS 3.7.4 NAT VoIP Router Adsl RIP Default is Disabled Border Gateway Default is Enabled 3.7.5 RIPStatic Route Misc Configuration Dhcp Relay Default at Dhcp Server Dhcp Target IP Default isTesting Ethernet LAN connection Diagnostic TestIgmp Proxy Default at Disabled Testing Adsl SynchronizationTest Ethernet connect to ATM Test ATM OAM Segment Loop BackTest ATM OAM End-to-End Loop Back Test IP connect to PPPSave Config Test Internet connectionProblem Corrective Action Problems with the WAN InterfaceProblems with the LAN Interface Technical Features Appendix B Support
Top Page Image Contents