Atlantis Land A02-RAV211 manual Factory Default Settings, Username and Password

Page 21

VoIP ROUTER ADSL

3.4 Factory Default Settings

Before configurating this ADSL VoIP Router, you need to know the following default settings.

•Username: admin

•Password : atlantis

•IP Address : 192.168.1.254

•Subnet Mask : 255.255.255.0

•DHCP server is enabled.

3.4.1 Username and Password

The default username and password are admin and atlantis respectively.

If you ever forget the password to log in, you may press the RESET button to restore the factory default settings..

3.4.2 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.

15

Image 21

Contents VoIP Router Adsl Page CE Mark Warning CopyrightImportant Note FCC WarningTable of Contents Chapter Chapter Page An Overview of the VoIP Router Adsl IntroductionVoIP Router Adsl Features Package ContentsPage VoIP Router Adsl Application Rear Ports Front LEDsCabling Connecting the VoIP Router Adsl Before ConfigurationFor Windows 95/98/ME Configuring PC in WindowsVoIP Router Adsl For Windows NT4.0 For Windows Click OK to finish the configuration For Windows XP VoIP Router Adsl Username and Password Factory Default SettingsInformation from the ISP Configuring with the Web BrowserQuick Start StatusStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status LAN Status TCP Status Status LAN StatusStatus- Learned MAC Table Status- PPP StatusSystem Log Routing TableSecurity Logs Quick StartAdsl Quick Start Configuration VoIP Quick StartVoIP System Firewall Virtual Server Advanced 3.1 WAN VoIP Router Adsl Service Category Select UBR or CBR Dhcp Client Static IP SettingsMAC Spoofing 3.2 LAN Dhcp Server Device IP AddressVoIP VoIP Router Adsl AuthorizationUserID Same as UserID Phone Book Call Feature CallWaiting Enable/Disable the call waiting featureCallForwarding CallReturn Enable/Disable the call return feature Advanced Telephony SettingsConfigure Caller ID info Echo Cancellation Tail Length Setting the Tail Length Ring & Tone Configuration Timeouts System Time Zone PasswordUpgrade Factory SettingRestart Packet Filtering FirewallVoIP Router Adsl Intrusion Detection Bridge FilteringBlock WAN Request Advanced Virtual Server3.7.2 DNS AdslDynamic DNS 3.7.4 NAT VoIP Router Adsl 3.7.5 RIP RIP Default is Disabled Border Gateway Default is EnabledStatic Route Dhcp Relay Default at Dhcp Server Dhcp Target IP Default is Misc ConfigurationIgmp Proxy Default at Disabled Diagnostic TestTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM End-to-End Loop Back Test ATM OAM Segment Loop BackTest Ethernet connect to ATM Test IP connect to PPPTest Internet connection Save ConfigProblems with the WAN Interface Problems with the LAN InterfaceProblem Corrective Action Technical Features Support Appendix B