Asante Technologies 35160 user manual Example

To assign a Priority Group to an interface, type p in the QoS Priority Queue Management Menu to access the Priority Group Configuration Menu. Only one list can be assigned per interface. Type g to set the Priority Group, or type the corresponding command letter to select another task.

IntraCore	35160-T Priority Group Configuration Menu		Port: [01]
Port Name:	<none>
Priority Group Info:
[+: Priority Group Enabled, -: No Priority Group]
Priority Group Status:		[01]-------- [09]--------
Priority List Number:		[<none>]
<Cmd>	<Description>
u	Display Priority Group
g	Set Priority Group
o	Remove Priority Group
r	Reset Priority Group Configuration to Factory Default
q	Return to previous menu
root>

S)elect port N)ext port P)rev port

Example:

Set TELNET traffic as high priority traffic on ingress port 10.

First, create Priority List 1, by following these steps:

1.Type i in the QoS Priority Queue Management Menu.

2.Enter queue list number 1.

3.Select p to choose protocol.

4.Select TCP by typing t.

5.Enter the layer 4 port number (Telnet is 23).

6.Set the priority (L, N, M, or H, as shown).

7.Type y to save the configuration, or n to cancel.

Enter queue list number (1 - 16) > 1

Please select classifier type Protocol or Ingress port (p/i) > Please select TCP or UDP (t/u) >

Enter layer 4 port number (1 - 65536) > 23

Please set priority (L: Low, N: Normal, M: Medium, H: High) > Save "priority-list 1 protocol ip high tcp 12" ? (y/n) >

Next, you can assign Priority List 1 on port 10 as a priority group:

1.From the Priority Group Configuration Menu, type g to set a Priority Group.

2.Enter the port number (1 through 16), in this case, 10.

3.Follow the onscreen instructions to assign Priority List 1 to port 10.

36