USING THE 197Bug
DEBUGGER
4
Entering Debugger Command Lines
197Bug is
As the command line is entered, it is stored in an internal buffer. Execution begins only after the carriage return is entered, thus allowing the user to correct entry errors, if necessary, using the control characters described in the Debugger General Information chapter in this guide.
When a command is entered, the debugger executes the command and the prompt reappears. However, if the command entered causes execution of user target code, for example GO, then control may or may not return to the debugger, depending on what the user program does. For example, if a breakpoint has been specified, then control returns to the debugger when the breakpoint is encountered during execution of the user program. Alternately, the user program could return to the debugger by means of the TRAP #496 function “.RETURN”.
In general, a debugger command is made up of the following parts:
1.The command identifier (i.e., MD or md for the Memory Display command). Note that either upper- or lowercase is allowed.
2.A port number if the command is set up to work with more than one port.
3.At least one intervening space before the first argument.
4.Any required arguments, as specified by command.
5.An option field, set off by a semicolon (;) to specify conditions other than the default conditions of the command.