Motorola MVME197LE manual 01FFFFFF

A

Configure and Environment Commands

Table A-1. ENV Command Parameters (Continued)

ENV Parameter and Options	Default	Meaning of Default
Memory Size Ending Address	02000000	The default ending
		address is the calculated
		size of local memory.
		The beginning address
Base Address of Local Memory	00000000	of Local Memory. It
		must be a multiple of
		the Local Memory board
		size, starting with 0. The
		Bug will set up the
		hardware address
		decoders so that the
		Local Memory resides
		as one contiguous block
		at this address. Default
		is $0.
Size of Local Memory	02000000	The default is the
		calculated size of the
		local memory.

Slave address decoders setup. The slave address decoders are use to allow another VMEbus master to access a local resource of the MVME197LE. There are two slave address decoders set. They are set up as follows.

Slave Enable #1 [Y/N]

Slave Starting Address #1

Slave Ending Address #1

Y

00000000

01FFFFFF

Setup and Enable the Slave Address Decoder #1.

Base address of the local resource that is accessible by the VMEbus. Default is the base of local memory, $0.

Ending address of the local resource that is accessible by the VMEbus. Default is the end of calculated memory.

A-8 Installation Guide