PLAY WITH DOLBY PRO LOGIC
1Press VIDEO/AUX/5.1CH and start playback of the
video source.
“VIDEO” is displayed.
If “5.1 ch IN” is displayed, press VIDEO/AUX/5.1CH again.
2Press DOLBY PRO LOGIC.
“NORMAL” is selected, and the playback sound has the DOLBY PRO LOGIC effect.
To cancel Dolby Pro Logic mode
Press DOLBY PRO LOGIC repeatedly until “OFF” is displayed.
To change the sound levels during playback
After adjusting the balance with the noise sequencer, the sound levels of the center or each surround speaker can be adjusted during playback of laser discs or video software.
1Press MANUAL SELECT on the remote control repeatedly to select “CEN” (center speaker),
2While the “CEN”
ADDITIONAL DOLBY PRO LOGIC MODES
In addition to the NORMAL mode, this unit is also equipped with the PHANTOM and the 3 STEREO modes.
PHANTOM mode: Use this mode when no center speaker is connected. The center channel signals are output through the left and right speakers.
3 STEREO mode: Use this mode when no surround speakers are connected. This mode reproduces rear sounds through the front speakers.
To select PHANTOM or 3 STEREO
Press DOLBY PRO LOGIC repeatedly until the desired DOLBY PRO LOGIC mode is displayed. The DOLBY PRO LOGIC mode is displayed cyclically as follows.
| NORMAL |
|
| PHANTOM |
| 3 STEREO |
| |
|
|
|
| |||||
|
|
|
| OFF (cancel) |
|
|
| |
|
|
|
|
|
|
|
To adjust the balance of connected speaker sound levels
Carry out steps 2 to 4 of “ADJUSTING SPEAKER LEVEL BALANCE”.
•Depending on the sound source and/or listening conditions, a surround effect may not be obtained even when the DOLBY PRO LOGIC is on.
•The full DOLBY PRO LOGIC effect cannot be obtained when using software without Hmark. In this case, use the DSP SURROUND system instead. (See page 11.)
•The DOLBY PRO LOGIC is automatically canceled when:
-the ECHO level is changed.
-the DSP SURROUND system or the BBE is turned on.
-the headphones are plugged in.
-the Karaoke function is turned on.
-the 5.1 CH (page 29) is selected.
•Set the microphone volume to OFF while the DOLBY PRO LOGIC is on. Otherwise, the DOLBY PRO LOGIC sound cannot be reproduced correctly.