Billion Electric Company 7100SV manual Information from ISP, LAN Port WAN Port IP address

Chapter 3 Configuration

3.2.1 Password

The default username and password are admin and password respectively.

If you ever forget the password to log in, you may press the RESET button up to 2 seconds to restore the factory default settings.

3.2.2 LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.

	LAN Port	WAN Port
IP address	192.168.1.254
Subnet Mask	255.255.255.0	Obtain an IP address
DHCP server function	Enabled	automatically. ISP assigns
IP addresses for	100 IP addresses continuing from	this IP address.
	192.168.1.100 through 192.168.1.199
distribution to PCs	(Actually, it can supports up to 253 users.)

3.3 Information from ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of service is provided such as PPPoE, PPPoA, RFC1483, IPoA, or PPTP-to-PPPoA Relaying.

Gather the information as illustrated in the following table and keep it for reference.

PPPoE

PPPoA

RFC1483 Bridged

RFC1483 Routed

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, Service Name, and Domain Name System (DNS) IP address (it can be automatically assigned by your ISP when you connect or be set manually).

VPI/VCI, VC-based/LLC-based multiplexing, Username, Password, and Domain Name System (DNS) IP address (it can be automatically assigned by your ISP when you connect or be set manually).

VPI/VCI, VC-based/LLC-based multiplexing to use Bridged Mode.

VPI/VCI, VC-based/LLC-based multiplexing, IP address, Subnet mask, Gateway address, and Domain Name System (DNS) IP address (it is fixed IP address).

15