Billion Electric Company 7100SV manual Diagnostic Test, PPP Half Bridge Default at Disabled

Page 61

Chapter 3 Configuration

PPP Half Bridge: Default at Disabled.

PPPreconnect on WAN access: Default at Disabled. Select Enabled if you want to automatically re- establish the PPPoE/PPPoA session when disconnected by ISP.

3.4.3.7.8Diagnostic Test

As soon as you enter the test program, all tests will run automatically to diagnose the connection status of the device.

Checking LAN Connection

Testing Ethernet LAN connection

This test passes if the Ethernet LAN interface is working properly.

Checking ADSL Connection

Testing ADSL Synchronization

This test checks your DSL modem to see if it can successfully negotiate and establish a DSL connection with your service provider's central office equipments. The test returns PASS if a DSL connection is established.

If this test returns FAIL, please try the test again a few minutes after this test is completed. Since your DSL modem need a couple of seconds to a few minutes to establish the DSL connection depending on your phone line quality. If this test returns FAIL, make sure your phone line is connected to your DSL modem securely, and also check with your service provider to see if your service is activated.

57

Image 61

Contents Bipac 7100SV Page Chapter Appendix An Overview of Bipac 7100SV Chapter IntroductionBipac 7100SV Features Package ContentsIntroduction Bipac 7100SV Application Lit green when the LAN link is connected Lit green when power adapter is connectedFront LEDs MeaningCabling Rear PortsConfiguring PC in Windows XP Before ConfigurationBillion Bipac 7100SV VoIP Adsl Router Configuration Configuring PC in WindowsBillion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings LAN Port WAN Port IP address Information from ISPDhcp server function IP addresses forConfiguring with Web Browser Quick Start StatusStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP Status Status- PPP StatusRouting Table Status- Learned MAC TableSystem Log Adsl Quick Start Security LogsVoIP Quick Start Select Adapter 3.1 WANConfiguration Static IP Settings Service Category Select UBR or CBR Dhcp ClientMAC Spoofing Device IP Address 3.2 LANVoIP AuthorizationUserID Same as UserID ConfigurationService Provider Phone Book Dial Plan Call Feature CallForwarding 3.3.6 PTM Ring Tone Configuration Timer System PasswordTime Zone Upgrade Restart Factory SettingPacket Filtering FirewallBillion Bipac 7100SV VoIP Adsl Router Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Adsl Advanced3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Static Route Misc Configuration PPP Half Bridge Default at Disabled Diagnostic TestTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM End-to-End Loop Back Test ATM OAM Segment Loop BackTest Ethernet connect to ATM Test IP connect to PPPConfiguration Save Config Problems with the WAN Interface Corrective Action Problems Starting Up the Adsl Router Corrective ActionProblems with the LAN Interface Corrective Action Problems Connecting to a Remote Node or ISPContact Billion Appendix