Billion Electric Company 7100SV Test ATM OAM Segment Loop Back, Test ATM OAM End-to-End Loop Back

Page 62

Billion BIPAC 7100SV VoIP ADSL Router

If this test returns FAIL, all other tests will be skipped.

Checking Circuit 0 for Network Connection

Test ATM OAM Segment Loop Back

This test sends ATM OAM F5 Segment loop back request cells to the central office equipments through your DSL connection. This test will pass if response cell is received. Since your service provider might not support this test, your DSL modem could still work even if this test fails.

If this test fails consistently and your DSL modem seems not working, check to make sure the VPI and VCI are configured correctly.

This test returns FAIL if the DSL synchronization test failed.

Test ATM OAM End-to-End Loop Back

This test sends ATM OAM F5 End-to-End loop back request cells to the central office equipments through your DSL connection. This test returns PASS if response cell is received. Since your service provider might not support this test, your DSL modem could still work even if this test fails.

If this test return FAIL consistently and your DSL modem seems not working, check to make sure the VPI and VCI are configured correctly.

This test returns SKIPPED if the DSL synchronization test failed.

Test Ethernet connect to ATM

This test returns PASS if the ATM AAL5 module is loaded correctly in your DSL modem. If this test returns FAIL, an internal error has occurred.

This test returns SKIPPED if the DSL synchronization does not return PASS.

Test IP connect to PPP

This test returns PASS if your DSL modem has been assigned a valid IP address by your service provider through DHCP or your DSL modem is assigned a valid IP address statically.

If this test returns FAIL, run this test again a few minutes after this test is completed. If this test returns FAIL consistently and DHCP client is turned on in your DSL modem, check with your service provider. If this test returns FAIL consistently and your DSL modem is statically assigned an IP address, make sure the IP address is the correct one assigned by your service provider.

This test returns SKIPPED if “Ethernet connect to AAL5” test does not return PASS.

Test Internet connection

This test returns PASS if the gateway can be reached through ping request. The gateway is assigned by your service provider, or obtained from your service provider by PPP negotiation or DHCP negotiation.

58

Page 61 Page 63
Image 62
Page 61 Page 63
Contents Bipac 7100SV Page Chapter Appendix Chapter Introduction An Overview of Bipac 7100SVPackage Contents Bipac 7100SV FeaturesIntroduction Bipac 7100SV Application Front LEDs Lit green when power adapter is connectedLit green when the LAN link is connected MeaningRear Ports CablingBefore Configuration Configuring PC in Windows XPBillion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows ConfigurationBillion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings Dhcp server function Information from ISPLAN Port WAN Port IP address IP addresses forConfiguring with Web Browser Status Quick StartStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status Status- PPP Status LAN Status TCP StatusStatus- Learned MAC Table Routing TableSystem Log Security Logs Adsl Quick StartVoIP Quick Start 3.1 WAN Select AdapterConfiguration MAC Spoofing Service Category Select UBR or CBR Dhcp ClientStatic IP Settings 3.2 LAN Device IP AddressVoIP Configuration AuthorizationUserID Same as UserIDService Provider Phone Book Dial Plan Call Feature CallForwarding 3.3.6 PTM Ring Tone Configuration Timer Password SystemTime Zone Upgrade Factory Setting RestartFirewall Packet FilteringBillion Bipac 7100SV VoIP Adsl Router Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Advanced Adsl3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Static Route Misc Configuration Testing Ethernet LAN connection Diagnostic TestPPP Half Bridge Default at Disabled Testing Adsl SynchronizationTest Ethernet connect to ATM Test ATM OAM Segment Loop BackTest ATM OAM End-to-End Loop Back Test IP connect to PPPConfiguration Save Config Problems with the LAN Interface Corrective Action Problems Starting Up the Adsl Router Corrective ActionProblems with the WAN Interface Corrective Action Problems Connecting to a Remote Node or ISPAppendix Contact Billion
Top Page Image Contents