Billion Electric Company 7100SV manual Misc Configuration

Page 60

Billion BIPAC 7100SV VoIP ADSL Router

Add: Click this button to add a new static routing. When you click this button, the next figure appears.

Delete: Check the item you want to delete. Then, click the “Delete” button.

Destination / Subnet Mask / Gateway Address: Fill in these fields required by this Static Routing function.

3.4.3.7.7 MISC Configuration

HTTP server access: Default at Restricted.

HTTP server port: Default at 80.

FTP server: Default at Enabled.

TFTP server: Default at Disabled.

DMZ: Regarding the DMZ Host, it is a local computer exposed to the Internet. Therefore, an incoming packet will be checked by NAT algorithms in the ADSL Router, then passed to the DMZ host when the packet is not sent by hacker or not limited by the virtual server list.

DMZ HOST IP: Enter the IP address of the DMZ host.

DHCP Relay: Default at DHCP Server.

DHCP Target IP: Default is 0.0.0.0

IGMP Proxy: Default at Disabled.

56

Image 60

Contents Bipac 7100SV Page Chapter Appendix Chapter Introduction An Overview of Bipac 7100SVPackage Contents Bipac 7100SV FeaturesIntroduction Bipac 7100SV Application Lit green when power adapter is connected Lit green when the LAN link is connectedFront LEDs MeaningRear Ports CablingBefore Configuration Configuring PC in Windows XPBillion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows ConfigurationBillion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings Information from ISP LAN Port WAN Port IP addressDhcp server function IP addresses forConfiguring with Web Browser Status Quick StartStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status Status- PPP Status LAN Status TCP StatusStatus- Learned MAC Table Routing TableSystem Log Security Logs Adsl Quick StartVoIP Quick Start 3.1 WAN Select AdapterConfiguration Service Category Select UBR or CBR Dhcp Client Static IP SettingsMAC Spoofing 3.2 LAN Device IP AddressVoIP Configuration AuthorizationUserID Same as UserIDService Provider Phone Book Dial Plan Call Feature CallForwarding 3.3.6 PTM Ring Tone Configuration Timer Password SystemTime Zone Upgrade Factory Setting RestartFirewall Packet FilteringBillion Bipac 7100SV VoIP Adsl Router Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Advanced Adsl3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Static Route Misc Configuration Diagnostic Test PPP Half Bridge Default at DisabledTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM Segment Loop Back Test ATM OAM End-to-End Loop BackTest Ethernet connect to ATM Test IP connect to PPPConfiguration Save Config Problems Starting Up the Adsl Router Corrective Action Problems with the WAN Interface Corrective ActionProblems with the LAN Interface Corrective Action Problems Connecting to a Remote Node or ISPAppendix Contact Billion