Billion Electric Company 7100SV manual 3.2 LAN, Device IP Address

Page 33

Chapter 3 Configuration

MTU: Maximum Transmission Unit indicates the network stack of any packet is larger than this value will be fragmented before the transmission. During the PPP negotiation, the peer of the PPP connection will indicate its MRU and will be accepted. The actual MTU of the PPP connection will be set to the smaller one of MTU and the peer’s MRU. The default value is 1492.

MSS: Maximum Segment Size is the largest size of data that TCP will send in a single IP packet. When a connection is established between LAN client and a host in the WAN side, the LAN client and the WAN host will indicate their MSS during the TCP connection handshake. The default value is 1492.

Authentication: Default at “Auto”.

Automatic Reconnect: Check to enable this device to automatically re-establish the PPPoE session when disconnected by ISP.

3.4.3.2 LAN

This screen contains settings for LAN interface attached to the LAN port.

Device IP Address

IP Address: Default at 192.168.1.254.

This is the device IP address in LAN site. If you plan to change it to another IP address to a different range of IP subnet. Please make sure your PC is also located at the same IP subnet. Otherwise, you may not be able to access the router.

Subnet Mask: Default at 255.255.255.0.

DHCP Server

29

Image 33

Contents Bipac 7100SV Page Chapter Appendix An Overview of Bipac 7100SV Chapter IntroductionBipac 7100SV Features Package ContentsIntroduction Bipac 7100SV Application Lit green when the LAN link is connected Lit green when power adapter is connectedFront LEDs MeaningCabling Rear PortsConfiguring PC in Windows XP Before ConfigurationBillion Bipac 7100SV VoIP Adsl Router Configuration Configuring PC in WindowsBillion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings LAN Port WAN Port IP address Information from ISPDhcp server function IP addresses forConfiguring with Web Browser Quick Start StatusStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP Status Status- PPP StatusRouting Table Status- Learned MAC TableSystem Log Adsl Quick Start Security LogsVoIP Quick Start Select Adapter 3.1 WANConfiguration Service Category Select UBR or CBR Dhcp Client Static IP SettingsMAC Spoofing Device IP Address 3.2 LANVoIP AuthorizationUserID Same as UserID ConfigurationService Provider Phone Book Dial Plan Call Feature CallForwarding 3.3.6 PTM Ring Tone Configuration Timer System PasswordTime Zone Upgrade Restart Factory SettingPacket Filtering FirewallBillion Bipac 7100SV VoIP Adsl Router Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Adsl Advanced3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Static Route Misc Configuration PPP Half Bridge Default at Disabled Diagnostic TestTesting Ethernet LAN connection Testing Adsl SynchronizationTest ATM OAM End-to-End Loop Back Test ATM OAM Segment Loop BackTest Ethernet connect to ATM Test IP connect to PPPConfiguration Save Config Problems with the WAN Interface Corrective Action Problems Starting Up the Adsl Router Corrective ActionProblems with the LAN Interface Corrective Action Problems Connecting to a Remote Node or ISPContact Billion Appendix