Billion Electric Company 7100SV manual Configuration, AuthorizationUserID Same as UserID

Page 35

Chapter 3 Configuration

3.4.3.3.1 Configuration

This screen contains settings for configuring VoIP SIP module.

SIP: Enable/Disable to use SIP as VoIP call signaling protocol.

SIP Registration: Enable/Disable to register a SIP account in the SIP server (refer Service Provider section below) or not.

LocalSIPPort: Enter the local SIP port which device listens incoming request. (range from 5000 to 65535, default value is 5060)

MediaBasePort: It is known as RTP port, provide the based value from the media (RTP) ports that are assigned for various endpoints and the different call sessions that may exist within an end-point. (range from 5000 to 65535, default value is 5000)

UserID: This parameter holds the registration ID of the user within the SIP registrar.

Password: This parameter holds the password used for authentication within SIP registrar.

AuthorizationUserID: Same as UserID.

DisplayName: This parameter will be appeared on the Caller ID.

G.711U: Set the priority of voice compression to be used in the voice codec. Priority 1 owns the first priority and so on.

G.711A: Set the priority of voice compression to be used in the voice codec.

31

Image 35

Contents Bipac 7100SV Page Chapter Appendix An Overview of Bipac 7100SV Chapter IntroductionBipac 7100SV Features Package ContentsIntroduction Bipac 7100SV Application Meaning Lit green when power adapter is connectedLit green when the LAN link is connected Front LEDsCabling Rear PortsConfiguring PC in Windows XP Before ConfigurationBillion Bipac 7100SV VoIP Adsl Router Configuration Configuring PC in WindowsBillion Bipac 7100SV VoIP Adsl Router Configuring PC in Windows 95/98/ME Then select the DNS Configuration Configuring PC in Windows NT4.0 Factory Default Settings IP addresses for Information from ISPLAN Port WAN Port IP address Dhcp server functionConfiguring with Web Browser Quick Start StatusStatus Adsl Status Adsl Status WAN Status Adsl Status ATM Status Status LAN Status LAN Status TCP Status Status- PPP StatusRouting Table Status- Learned MAC TableSystem Log Adsl Quick Start Security LogsVoIP Quick Start Select Adapter 3.1 WANConfiguration MAC Spoofing Service Category Select UBR or CBR Dhcp ClientStatic IP Settings Device IP Address 3.2 LANVoIP AuthorizationUserID Same as UserID ConfigurationService Provider Phone Book Dial Plan Call Feature CallForwarding 3.3.6 PTM Ring Tone Configuration Timer System PasswordTime Zone Upgrade Restart Factory SettingPacket Filtering FirewallBillion Bipac 7100SV VoIP Adsl Router Bridge Filtering Intrusion Detection Block WAN Request Virtual Server Adsl Advanced3.7.2 DNS Dynamic DNS 3.7.4 NAT Configuration 3.7.5 RIP Static Route Misc Configuration Testing Adsl Synchronization Diagnostic TestPPP Half Bridge Default at Disabled Testing Ethernet LAN connectionTest IP connect to PPP Test ATM OAM Segment Loop BackTest ATM OAM End-to-End Loop Back Test Ethernet connect to ATMConfiguration Save Config Problems Connecting to a Remote Node or ISP Problems Starting Up the Adsl Router Corrective ActionProblems with the WAN Interface Corrective Action Problems with the LAN Interface Corrective ActionContact Billion Appendix