Iomega 03798300 owner manual Guide

Page 12

2a

Guide

Installation

3

3 1/2” drive bays ONLY.

To install your Zip® drive in a 3 1/2” drive bay, remove the mounting screws as illustrated and slide the drive out of the sled.

Check mounting requirements. Your drive bay may require side rails.

MHINT: Check other drives in the system (such as a CD drive) to see if they use mounting rails. If so, you may need similar mounting rails for

the Zip® Internal drive. If the computer does not include extra mounting rails, contact your computer dealer to obtain them. M

51/4" Bay

31/2" Bay

12

Image 12

Contents Internal Atapi Drive Table of Contents Welcome to Zip Drive Check system requirements Unpack the Zip Internal Atapi driveDisconnect the computer power cord Watch the instructional videoWrite down the serial number of your Zip Internal Atapi drive for future referenceIdentifying the computer’s IDE configuration Identify your computer’s IDE configuration Locate the IDE channels using the CD drive1b Locate the IDE channels using the computer’s hard drive Follow these instructions if you were unable to1c Possible IDE channel locations Determining your computer’s configuration If the hard drive is the only IDE device connectedInstallation Guide Check the jumper setting on the Zip drive Panel coverGuide Slide the Zip drive into the drive bay Remove the IDE Interface cable that isCurrently connected to your CD drive Verify that the jumper on your CD drive is set to Master Connect an internal computer power supply Cable to the Zip driveSecure drive in drive bay Guide Change the jumper setting to Master Locate a vacant 31/2 or 51/4 drive bayMay require side rails 2a3 1/2 drive bays onlyLocate the data cable that comes packaged With the Zip drive. Find the colored stripe orPrint on one side of the data cable showing PINZip drive Cable to your Zip drive Internal drive. MGuide If the Iomega software setup program does CD driveNot start automatically, follow these steps SoftwareAdditional instructions for your system Windows 95/98 UsersHow to Install Without a CD Drive Create Install Floppy DiskettesDownload Software from the Iomega Web Site Installation Guide Operating Your Zip Drive Inserting Zip DisksDisk Eject in Case of Power Loss Ejecting Zip DisksDrive Sleep Compatibility with 100MB Zip Disks Zip Tips Step Backup/Restore RecordIt SoftwareCopy Machine Iomega ToolsFor information on how to use IomegaWare software Drive ShortcutsBacking Up with Zip Disks Copying Zip DisksInstalling Applications to Zip Disks Formatting Zip DisksFormatting Zip Disks under Windows 95/98 or NT Setting Zip Disk Protection under Windows 95/98 and NT Read/Write Protecting Zip DisksWhat is IDE? What is ATAPI?Jumper Settings How IDE WorksPossible System IDE/ATAPI Configurations BIOS/CMOS SupportSlave Drive Master DriveTroubleshooting Green activity light on the Zip drive does not turn onTroubleshooting Data transfer problems or drive operation is erratic Installing the Zip drive changes other drive lettersWindows 95/98 Users Troubleshooting You want to use Windows 95/98 DOS mode with your Zip drive How to Get Help Automated Voice Technical SupportAutomated FAX-back Help 801 778-5763 U.S. & Canada One-on-One Iomega Technical SupportLimited Warranty Information Return or RepairProduct Information International Support NumbersRegulatory Information Model Number Z250ATAPI FCC United StatesCanadian Verification CE European CommunityVisit our web site