Iomega 03798300 owner manual Locate the data cable that comes packaged, Pin

Page 19

4 Slide the Zip® drive into the drive bay.

Installation

Guide

M NOTE: If it makes it easier to connect cables on your computer, you can secure the Zip® drive in the drive bay now. (See step 9 for instructions on securing the drive.) M

5	Locate the data cable that comes packaged
	Locate the data cable that comes packaged
	with the Zip® drive. Find the colored stripe or
	print on one side of the data cable showing
	PIN 1.

Stripe or printing shows the

PIN 1 side of the data cable.

Locate the PIN 1 connection on the IDE channel. PIN 1 on your computer’s IDE channels can be indicated by any of the following marks. If you have a keyed receptacle, you should only be able to connect the cable one way.

2		40
1	Keyed	39
	Keyed

Connector

19

Image 19

Contents Internal Atapi Drive Table of Contents Welcome to Zip Drive Unpack the Zip Internal Atapi drive Check system requirementsInternal Atapi drive for future reference Disconnect the computer power cordWatch the instructional video Write down the serial number of your ZipIdentifying the computer’s IDE configuration Follow these instructions if you were unable to Identify your computer’s IDE configurationLocate the IDE channels using the CD drive 1b Locate the IDE channels using the computer’s hard drive1c Possible IDE channel locations If the hard drive is the only IDE device connected Determining your computer’s configurationInstallation Guide Panel cover Check the jumper setting on the Zip driveGuide Remove the IDE Interface cable that is Slide the Zip drive into the drive bayCurrently connected to your CD drive Verify that the jumper on your CD drive is set to Master Cable to the Zip drive Connect an internal computer power supplySecure drive in drive bay Guide Locate a vacant 31/2 or 51/4 drive bay Change the jumper setting to Master2a3 1/2 drive bays only May require side railsPIN Locate the data cable that comes packagedWith the Zip drive. Find the colored stripe or Print on one side of the data cable showingZip drive Internal drive. M Cable to your Zip driveGuide Software If the Iomega software setup program doesCD drive Not start automatically, follow these stepsWindows 95/98 Users Additional instructions for your systemCreate Install Floppy Diskettes How to Install Without a CD DriveDownload Software from the Iomega Web Site Installation Guide Inserting Zip Disks Operating Your Zip DriveEjecting Zip Disks Disk Eject in Case of Power LossDrive Sleep Compatibility with 100MB Zip Disks Zip Tips Iomega Tools Step Backup/RestoreRecordIt Software Copy MachineDrive Shortcuts For information on how to use IomegaWare softwareCopying Zip Disks Backing Up with Zip DisksFormatting Zip Disks Installing Applications to Zip DisksFormatting Zip Disks under Windows 95/98 or NT Read/Write Protecting Zip Disks Setting Zip Disk Protection under Windows 95/98 and NTHow IDE Works What is IDE?What is ATAPI? Jumper SettingsMaster Drive Possible System IDE/ATAPI ConfigurationsBIOS/CMOS Support Slave DriveGreen activity light on the Zip drive does not turn on TroubleshootingTroubleshooting Installing the Zip drive changes other drive letters Data transfer problems or drive operation is erraticWindows 95/98 Users Troubleshooting You want to use Windows 95/98 DOS mode with your Zip drive Automated Voice Technical Support How to Get HelpOne-on-One Iomega Technical Support Automated FAX-back Help 801 778-5763 U.S. & CanadaInternational Support Numbers Limited Warranty InformationReturn or Repair Product InformationCE European Community Regulatory InformationModel Number Z250ATAPI FCC United States Canadian VerificationVisit our web site