Iomega 03798300 owner manual May require side rails, 2a3 1/2 drive bays only

Page 18

2a3 1/2” drive bays ONLY.

To install your Zip® drive in a 3 1/2” drive bay, remove the mounting screws as illustrated and slide the drive out of the sled.

Guide

Installation

3	Check mounting requirements. Your drive bay
	Check mounting requirements. Your drive bay
	may require side rails.
	M HINT: Check other drives in the system (such as a CD drive) to see
	if they use mounting rails. If so, you may need similar mounting rails
	for the Zip® Internal drive. If the computer does not include extra
	mounting rails, contact your computer dealer to obtain the them. M

51/4" Bay

31/2" Bay

18

Image 18

Contents Internal Atapi Drive Table of Contents Welcome to Zip Drive Check system requirements Unpack the Zip Internal Atapi driveWrite down the serial number of your Zip Disconnect the computer power cordWatch the instructional video Internal Atapi drive for future referenceIdentifying the computer’s IDE configuration 1b Locate the IDE channels using the computer’s hard drive Identify your computer’s IDE configurationLocate the IDE channels using the CD drive Follow these instructions if you were unable to1c Possible IDE channel locations Determining your computer’s configuration If the hard drive is the only IDE device connectedInstallation Guide Check the jumper setting on the Zip drive Panel coverGuide Slide the Zip drive into the drive bay Remove the IDE Interface cable that isCurrently connected to your CD drive Verify that the jumper on your CD drive is set to Master Connect an internal computer power supply Cable to the Zip driveSecure drive in drive bay Guide Change the jumper setting to Master Locate a vacant 31/2 or 51/4 drive bayMay require side rails 2a3 1/2 drive bays onlyPrint on one side of the data cable showing Locate the data cable that comes packagedWith the Zip drive. Find the colored stripe or PINZip drive Cable to your Zip drive Internal drive. MGuide Not start automatically, follow these steps If the Iomega software setup program doesCD drive SoftwareAdditional instructions for your system Windows 95/98 UsersHow to Install Without a CD Drive Create Install Floppy DiskettesDownload Software from the Iomega Web Site Installation Guide Operating Your Zip Drive Inserting Zip DisksDisk Eject in Case of Power Loss Ejecting Zip DisksDrive Sleep Compatibility with 100MB Zip Disks Zip Tips Copy Machine Step Backup/RestoreRecordIt Software Iomega ToolsFor information on how to use IomegaWare software Drive ShortcutsBacking Up with Zip Disks Copying Zip DisksInstalling Applications to Zip Disks Formatting Zip DisksFormatting Zip Disks under Windows 95/98 or NT Setting Zip Disk Protection under Windows 95/98 and NT Read/Write Protecting Zip DisksJumper Settings What is IDE?What is ATAPI? How IDE WorksSlave Drive Possible System IDE/ATAPI ConfigurationsBIOS/CMOS Support Master DriveTroubleshooting Green activity light on the Zip drive does not turn onTroubleshooting Data transfer problems or drive operation is erratic Installing the Zip drive changes other drive lettersWindows 95/98 Users Troubleshooting You want to use Windows 95/98 DOS mode with your Zip drive How to Get Help Automated Voice Technical SupportAutomated FAX-back Help 801 778-5763 U.S. & Canada One-on-One Iomega Technical SupportProduct Information Limited Warranty InformationReturn or Repair International Support NumbersCanadian Verification Regulatory InformationModel Number Z250ATAPI FCC United States CE European CommunityVisit our web site