Iomega 03798300 Slide the Zip drive into the drive bay, Remove the IDE Interface cable that is

Page 13

4 Slide the Zip® drive into the drive bay.

Installation

Guide

M NOTE: If it makes it easier to connect cables on your computer, you can secure the Zip® drive in the drive bay now. (See step 9 for instructions on securing the drive.) M

5	Remove the IDE Interface cable that is
	Remove the IDE Interface cable that is
	currently connected to your CD drive.
	Find the flat, wide cable connected to the back of the CD drive. Note the
	side of the cable with the red stripe or PIN 1 indicator and disconnect the
	cable from the motherboard and the CD drive and set it aside.

Existing IDE

Data Cable

From CD drive

Existing IDE

Data Cable

From Hard Drive

13

Image 13

Contents Internal Atapi Drive Table of Contents Welcome to Zip Drive Unpack the Zip Internal Atapi drive Check system requirementsWatch the instructional video Disconnect the computer power cordWrite down the serial number of your Zip Internal Atapi drive for future referenceIdentifying the computer’s IDE configuration Locate the IDE channels using the CD drive Identify your computer’s IDE configuration1b Locate the IDE channels using the computer’s hard drive Follow these instructions if you were unable to1c Possible IDE channel locations If the hard drive is the only IDE device connected Determining your computer’s configurationInstallation Guide Panel cover Check the jumper setting on the Zip driveGuide Remove the IDE Interface cable that is Slide the Zip drive into the drive bayCurrently connected to your CD drive Verify that the jumper on your CD drive is set to Master Cable to the Zip drive Connect an internal computer power supplySecure drive in drive bay Guide Locate a vacant 31/2 or 51/4 drive bay Change the jumper setting to Master2a3 1/2 drive bays only May require side railsWith the Zip drive. Find the colored stripe or Locate the data cable that comes packagedPrint on one side of the data cable showing PINZip drive Internal drive. M Cable to your Zip driveGuide CD drive If the Iomega software setup program doesNot start automatically, follow these steps SoftwareWindows 95/98 Users Additional instructions for your systemCreate Install Floppy Diskettes How to Install Without a CD DriveDownload Software from the Iomega Web Site Installation Guide Inserting Zip Disks Operating Your Zip DriveEjecting Zip Disks Disk Eject in Case of Power LossDrive Sleep Compatibility with 100MB Zip Disks Zip Tips RecordIt Software Step Backup/RestoreCopy Machine Iomega ToolsDrive Shortcuts For information on how to use IomegaWare softwareCopying Zip Disks Backing Up with Zip DisksFormatting Zip Disks Installing Applications to Zip DisksFormatting Zip Disks under Windows 95/98 or NT Read/Write Protecting Zip Disks Setting Zip Disk Protection under Windows 95/98 and NTWhat is ATAPI? What is IDE?Jumper Settings How IDE WorksBIOS/CMOS Support Possible System IDE/ATAPI ConfigurationsSlave Drive Master DriveGreen activity light on the Zip drive does not turn on TroubleshootingTroubleshooting Installing the Zip drive changes other drive letters Data transfer problems or drive operation is erraticWindows 95/98 Users Troubleshooting You want to use Windows 95/98 DOS mode with your Zip drive Automated Voice Technical Support How to Get HelpOne-on-One Iomega Technical Support Automated FAX-back Help 801 778-5763 U.S. & CanadaReturn or Repair Limited Warranty InformationProduct Information International Support NumbersModel Number Z250ATAPI FCC United States Regulatory InformationCanadian Verification CE European CommunityVisit our web site