Technics DP-1810P manual Job Memory, To store a job in memory, To recall a job stored in memory

Page 19

Creative Features

Job Memory

Two Copy Jobs Can Be Programmed in Memory (M1, M2) for recall at a later time.

JOB MEMORY

PRESS M1,M2 TO STORE.

To store a job in memory

#Set up the copy job to be stored in memory, by first selecting each function you wish the copier to perform.

$Press the Memory In (F2) key.

%Press the M1 (F3) or M2 (F4) key.

Making Copies

RECALL JOB MEMORY

LOADING...

To recall a job stored in memory

&Place the Original

(Press the M1 (F3) or M2 (F4) key. The stored contents will be displayed.

)Press START

NOTE

CStored job(s) will not be deleted even if the power switch is turned Off.

CWhen storing a new job into programmed memory, the previously stored job

 

 

will be overwritten.

19

Image 19
Contents Options Before StartingEnglish Others Model and Serial Number Important InformationCommon Features and Usage Operation ChartEnergy Star Table of Contents Options Problem SolvingOthers Manufacturer’s name and address Factory ID PrecautionsFor Your Safety Laser SafetyToner and Paper Ventilation HandlingFCC Warning For U.S.A InstallationControl Panel Interrupt Key, Memory In Key, M1/M2 Keys Contents Refer to Stop KeyLCD Display Start Key$Select exposure control Basic CopyFull Size Copying Copying the Same Size OriginalsSize Copying with Preset RatiosReset Reduction or Enlargement CopyingZoom Zoom CopyingSheet Bypass Side Guides Using the Sheet Bypass$Adjust the side guides Copying on Special Paper, etc1 key Creative FeaturesProcedure 1 CopyCopy CopyMargin Book/Edge/MarginBook Edge$Press the Memory In F2 key Job MemoryTo store a job in memory To recall a job stored in memorySort Copy Sort CopyFrom Platen Glass only Sleep Mode Other FeaturesEnergy Saver/Interrupt Mode Energy Saver ModeNormal Skyshot ModeDigital Skyshot Mode NonePlaten Manual Skyshot ModeCopy Combined Function TableOriginal SortInput Identification Code Using Function Modes to Change the Initial Copy ModesFunction OptionsGeneral Functions Modes Function Initial SettingModes Function Copier SettingsGeneral Functions for Key Operator Copier Settings for Key Operator Changing the Auto Exposure Setting Function SettingPress the Function Key Proceed as Follows Changing the Paper Size Function Setting for Key OperatorB5R Stopper Guide a Paper Guide b PaperFunctions Departmental CounterSelect the Department Counter Mode Components Accessories$2 in 1 Copy Automatic Document FeederADF DA-AS180 # Automatic Original FeedingInappropriate originals Place OriginalAdding Paper J Problem SolvingSheet Paper Tray Cap Adding the Toner and Replacing Toner Waste Container ?Problem Solving Paper Misfeed Locations Removing a Misfed PaperPaper Exit Area Surface Paper Entry/Transport AreaHot HeatedPaper Feed Module ADF Unit Does Not Operate TroubleshootingBefore Calling Service Check ActionMarked Copies Light CopiesGlass User Error Codes U CodeCode Display Message Check Points CoverDP-1810P Copier Specifications2nd Paper Feed Module DA-DS182 SpecificationsPart Name Remarks Options and SuppliesFor Printer SuppliesPage Page Warranty