Technics DP-1810P manual Select the Department Counter Mode

Page 34

Function

Function Setting for Key Operator

3 Select the Department Counter Mode.

14 DEPT.COUNTER MODE 1:TOTAL COUNTER

DEPT. CODE (01-50) ENTER NO. OR ∨ ∧

Press 2 and the SET key.

4 Change the Department ID Code, limit the maximum number of copies and department Counter number.

I.D CODE 01:1234

MAX COPIES 01:123456

DEPT.COUNTER

01:123456

#Press the Keypad and the SET key to input the Department ID Code.

01: 1234 Department ID Code Department No.

$Press the Keypad and the SET key to input the maximun number of copies.

01: 123456

 

Maximun number of copies (6 digits)

 

Department No.

%Press the Keypad and the SET key (G or F keys) to select the Department No.

01: 123456

 

Counter (6 digits)

 

Department No.

&Press 0 and the SET key (Input “0”) to clear the counter.

NOTE

CTo reset the function mode, press the RESET key.

 

34

Image 34
Contents Options Before StartingEnglish Others Important Information Model and Serial NumberOperation Chart Common Features and UsageEnergy Star Table of Contents Options Problem SolvingOthers Laser Safety PrecautionsFor Your Safety Manufacturer’s name and address Factory IDHandling Toner and Paper VentilationInstallation FCC Warning For U.S.AControl Panel Start Key Contents Refer to Stop KeyLCD Display Interrupt Key, Memory In Key, M1/M2 KeysCopying the Same Size Originals Basic CopyFull Size Copying $Select exposure controlReduction or Enlargement Copying Copying with Preset RatiosReset SizeZoom Copying ZoomCopying on Special Paper, etc Using the Sheet Bypass$Adjust the side guides Sheet Bypass Side Guides1 Copy Creative FeaturesProcedure 1 keyCopy CopyEdge Book/Edge/MarginBook MarginTo recall a job stored in memory Job MemoryTo store a job in memory $Press the Memory In F2 keySort Copy Sort CopyFrom Platen Glass only Energy Saver Mode Other FeaturesEnergy Saver/Interrupt Mode Sleep ModeNone Skyshot ModeDigital Skyshot Mode NormalManual Skyshot Mode PlatenSort Combined Function TableOriginal CopyOptions Using Function Modes to Change the Initial Copy ModesFunction Input Identification CodeModes Function Initial Setting General FunctionsCopier Settings Modes FunctionGeneral Functions for Key Operator Copier Settings for Key Operator Changing the Auto Exposure Setting Function SettingPress the Function Key Proceed as Follows Changing the Paper Size Function Setting for Key OperatorB5R Paper Stopper Guide a Paper Guide bDepartmental Counter FunctionsSelect the Department Counter Mode Accessories Components# Automatic Original Feeding Automatic Document FeederADF DA-AS180 $2 in 1 CopyPlace Original Inappropriate originalsAdding Paper J Problem SolvingSheet Paper Tray Adding the Toner and Replacing Toner Waste Container ? CapProblem Solving Removing a Misfed Paper Paper Misfeed LocationsPaper Exit Area Heated Paper Entry/Transport AreaHot SurfacePaper Feed Module ADF Check Action TroubleshootingBefore Calling Service Unit Does Not OperateLight Copies Marked CopiesCover User Error Codes U CodeCode Display Message Check Points GlassSpecifications DP-1810P CopierSpecifications 2nd Paper Feed Module DA-DS182Supplies Options and SuppliesFor Printer Part Name RemarksPage Page Warranty