Technics DP-1810P manual Paper Entry/Transport Area, Hot, Heated, Surface

Page 43

Problem Solving

■ Paper Entry/Transport Area

CMake sure that the misfeed indicator goes off after removing all misfed paper.

1	Open the right cover.

2		Remove the misfed paper.
		Remove the misfed paper.
3		If copy paper is fed far into the copier;
		If copy paper is fed far into the copier;
		#Turn the right paper clearing knob.
		$Remove the misfed paper.
4		#Open the heat roller cover.
		$Remove the misfed paper.
		%Close the right cover.
	Caution	Caution: This fuser area may be
	heated	hot.
	surface
		I

ATTENTION CMake sure that the misfeed indicator goes off after removing all misfed paper.

Image 43

Contents Options Before StartingEnglish Others Model and Serial Number Important InformationCommon Features and Usage Operation ChartEnergy Star Table of Contents Options Problem SolvingOthers Manufacturer’s name and address Factory ID PrecautionsFor Your Safety Laser SafetyToner and Paper Ventilation HandlingFCC Warning For U.S.A InstallationControl Panel Interrupt Key, Memory In Key, M1/M2 Keys Contents Refer to Stop KeyLCD Display Start Key$Select exposure control Basic CopyFull Size Copying Copying the Same Size OriginalsSize Copying with Preset RatiosReset Reduction or Enlargement CopyingZoom Zoom CopyingSheet Bypass Side Guides Using the Sheet Bypass$Adjust the side guides Copying on Special Paper, etc1 key Creative FeaturesProcedure 1 CopyCopy CopyMargin Book/Edge/MarginBook Edge$Press the Memory In F2 key Job MemoryTo store a job in memory To recall a job stored in memorySort Copy Sort CopyFrom Platen Glass only Sleep Mode Other FeaturesEnergy Saver/Interrupt Mode Energy Saver ModeNormal Skyshot ModeDigital Skyshot Mode NonePlaten Manual Skyshot ModeCopy Combined Function TableOriginal SortInput Identification Code Using Function Modes to Change the Initial Copy ModesFunction OptionsGeneral Functions Modes Function Initial SettingModes Function Copier SettingsGeneral Functions for Key Operator Copier Settings for Key Operator Changing the Auto Exposure Setting Function SettingPress the Function Key Proceed as Follows Changing the Paper Size Function Setting for Key OperatorB5R Stopper Guide a Paper Guide b PaperFunctions Departmental CounterSelect the Department Counter Mode Components Accessories$2 in 1 Copy Automatic Document FeederADF DA-AS180 # Automatic Original FeedingInappropriate originals Place OriginalAdding Paper J Problem SolvingSheet Paper Tray Cap Adding the Toner and Replacing Toner Waste Container ?Problem Solving Paper Misfeed Locations Removing a Misfed PaperPaper Exit Area Surface Paper Entry/Transport AreaHot HeatedPaper Feed Module ADF Unit Does Not Operate TroubleshootingBefore Calling Service Check ActionMarked Copies Light CopiesGlass User Error Codes U CodeCode Display Message Check Points CoverDP-1810P Copier Specifications2nd Paper Feed Module DA-DS182 SpecificationsPart Name Remarks Options and SuppliesFor Printer SuppliesPage Page Warranty

Problem Solving

■ Paper Entry/Transport Area

heated

hot.

surface