Technics DP-1810P manual Problem Solving, Adding Paper J, Sheet Paper Tray

Page 38

Problem Solving

Adding Paper (J)

■550-Sheet Paper Tray

1

Pull the paper tray out.

 

2

Place the paper with the copying

surface facing upward.

Special papers, like glossy paper, mailing

labels and transparencies cannot be used

 

in the paper tray. Use the sheet bypass

 

for special paper.

3

Make sure paper is not loaded

 

 

above the overfill indicator located

 

in the paper tray.

4

Firmly push the paper tray back

 

 

into the copier.

ATTENTION

CDo not use paper with folds or wrinkles.

Refer to page 30 for details on changing the paper size for the paper tray.

 

CUnused paper should always be placed into a bag and the opening should be sealed for storage.

If the paper is left exposed, problems such as paper curl, paper jams, wrinkles or loss of copied image quality may occur.

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents English Others Before StartingOptions Important Information Model and Serial NumberOperation Chart Common Features and UsageEnergy Star Table of Contents Others Problem SolvingOptions Laser Safety PrecautionsFor Your Safety Manufacturer’s name and address Factory IDHandling Toner and Paper VentilationInstallation FCC Warning For U.S.AControl Panel Start Key Contents Refer to Stop KeyLCD Display Interrupt Key, Memory In Key, M1/M2 KeysCopying the Same Size Originals Basic CopyFull Size Copying $Select exposure controlReduction or Enlargement Copying Copying with Preset RatiosReset SizeZoom Copying ZoomCopying on Special Paper, etc Using the Sheet Bypass$Adjust the side guides Sheet Bypass Side Guides1 Copy Creative FeaturesProcedure 1 keyCopy CopyEdge Book/Edge/MarginBook MarginTo recall a job stored in memory Job MemoryTo store a job in memory $Press the Memory In F2 keyFrom Platen Glass only Sort CopySort Copy Energy Saver Mode Other FeaturesEnergy Saver/Interrupt Mode Sleep ModeNone Skyshot ModeDigital Skyshot Mode NormalManual Skyshot Mode PlatenSort Combined Function TableOriginal CopyOptions Using Function Modes to Change the Initial Copy ModesFunction Input Identification CodeModes Function Initial Setting General FunctionsCopier Settings Modes FunctionGeneral Functions for Key Operator Copier Settings for Key Operator Press the Function Key Proceed as Follows Function SettingChanging the Auto Exposure Setting B5R Function Setting for Key OperatorChanging the Paper Size Paper Stopper Guide a Paper Guide bDepartmental Counter FunctionsSelect the Department Counter Mode Accessories Components# Automatic Original Feeding Automatic Document FeederADF DA-AS180 $2 in 1 CopyPlace Original Inappropriate originalsSheet Paper Tray Problem SolvingAdding Paper J Adding the Toner and Replacing Toner Waste Container ? CapProblem Solving Removing a Misfed Paper Paper Misfeed LocationsPaper Exit Area Heated Paper Entry/Transport AreaHot SurfacePaper Feed Module ADF Check Action TroubleshootingBefore Calling Service Unit Does Not OperateLight Copies Marked CopiesCover User Error Codes U CodeCode Display Message Check Points GlassSpecifications DP-1810P CopierSpecifications 2nd Paper Feed Module DA-DS182Supplies Options and SuppliesFor Printer Part Name RemarksPage Page Warranty
Top Page Image Contents