Technics DP-1810P manual Problem Solving

Page 40

Problem Solving

Adding the Toner and Replacing Toner Waste Container (?)

52 1

#Shake the new toner bottle four or five times to loosen the contents.

$Remove the cap from the toner bottle.

6	1
	1
2	2-1	2-3
	2-2
	Incorrect	Correct

#Align the Key of the bottle, also represented by the Arrow mark

(Unlocked symbol ) visible on the end of the Toner Bottle with the Arrow mark on the machine.

Note:To prevent toner spill, ensure that the key is facing upwards before installing the bottle.

$Insert the bottle as far as it will go, then turn it clockwise (160°, approx. 1/2 turn) until it locks (Locked symbol ).

Note: If the bottle is not inserted all the way into the machine as illustrated, turn the bottle slightly in either direction to engage the key and try it again.

7

8

Install a new toner waste container.

Close the front cover.

ATTENTION CDo not reuse the toner from the Toner Waste Container.

40

Image 40

Contents Options Before StartingEnglish Others Important Information Model and Serial NumberOperation Chart Common Features and UsageEnergy Star Table of Contents Options Problem SolvingOthers Precautions For Your SafetyLaser Safety Manufacturer’s name and address Factory IDHandling Toner and Paper VentilationInstallation FCC Warning For U.S.AControl Panel Contents Refer to Stop Key LCD DisplayStart Key Interrupt Key, Memory In Key, M1/M2 KeysBasic Copy Full Size CopyingCopying the Same Size Originals $Select exposure controlCopying with Preset Ratios ResetReduction or Enlargement Copying SizeZoom Copying ZoomUsing the Sheet Bypass $Adjust the side guidesCopying on Special Paper, etc Sheet Bypass Side GuidesCreative Features Procedure1 Copy 1 keyCopy CopyBook/Edge/Margin BookEdge MarginJob Memory To store a job in memoryTo recall a job stored in memory $Press the Memory In F2 keySort Copy Sort CopyFrom Platen Glass only Other Features Energy Saver/Interrupt ModeEnergy Saver Mode Sleep ModeSkyshot Mode Digital Skyshot ModeNone NormalManual Skyshot Mode PlatenCombined Function Table OriginalSort CopyUsing Function Modes to Change the Initial Copy Modes FunctionOptions Input Identification CodeModes Function Initial Setting General FunctionsCopier Settings Modes FunctionGeneral Functions for Key Operator Copier Settings for Key Operator Changing the Auto Exposure Setting Function SettingPress the Function Key Proceed as Follows Changing the Paper Size Function Setting for Key OperatorB5R Paper Stopper Guide a Paper Guide bDepartmental Counter FunctionsSelect the Department Counter Mode Accessories ComponentsAutomatic Document Feeder ADF DA-AS180# Automatic Original Feeding $2 in 1 CopyPlace Original Inappropriate originalsAdding Paper J Problem SolvingSheet Paper Tray Adding the Toner and Replacing Toner Waste Container ? CapProblem Solving Removing a Misfed Paper Paper Misfeed LocationsPaper Exit Area Paper Entry/Transport Area HotHeated SurfacePaper Feed Module ADF Troubleshooting Before Calling ServiceCheck Action Unit Does Not OperateLight Copies Marked CopiesUser Error Codes U Code Code Display Message Check PointsCover GlassSpecifications DP-1810P CopierSpecifications 2nd Paper Feed Module DA-DS182Options and Supplies For PrinterSupplies Part Name RemarksPage Page Warranty