Technics DP-1810P manual Light Copies, Marked Copies

Page 47

Troubleshooting

2.The Toner Charging Mode starts and the LCD displays:

CHARGING TONER

Add Toner Warning Indicator:

CFlashing = Toner Bottle is nearly empty

CLit	= Toner Bottle is empty

3. This message is displayed for approximately 200 seconds.

CHARGING TONER

.....

∗ C Each “.” is approximately 10 sec.

4.This massage will continue to be displayed until the warm-up cycle is completed, and if the toner bottle was replaced, upon completion, the Add Toner Warning Indicator automatically turns Off.

Check

Action

Light Copies

Does the exposure indicator say “Lighter”?

Press the Darker key until the indicator LED is set to Darker. (See page 12)

(Yes)

(No)

Does the add toner indicator and message appear on the display? (?)

Add the Toner. (See page 38)

(Yes)

Marked Copies

Is the copier platen glass or platen cover dirty?

Clean the glass or platen cover. (See below)

(Yes)

47	Others
47

Image 47

Contents English Others Before StartingOptions Model and Serial Number Important InformationCommon Features and Usage Operation ChartEnergy Star Table of Contents Others Problem SolvingOptions Manufacturer’s name and address Factory ID PrecautionsFor Your Safety Laser SafetyToner and Paper Ventilation HandlingFCC Warning For U.S.A InstallationControl Panel Interrupt Key, Memory In Key, M1/M2 Keys Contents Refer to Stop KeyLCD Display Start Key$Select exposure control Basic CopyFull Size Copying Copying the Same Size OriginalsSize Copying with Preset RatiosReset Reduction or Enlargement CopyingZoom Zoom CopyingSheet Bypass Side Guides Using the Sheet Bypass$Adjust the side guides Copying on Special Paper, etc1 key Creative FeaturesProcedure 1 CopyCopy CopyMargin Book/Edge/MarginBook Edge$Press the Memory In F2 key Job MemoryTo store a job in memory To recall a job stored in memoryFrom Platen Glass only Sort CopySort Copy Sleep Mode Other FeaturesEnergy Saver/Interrupt Mode Energy Saver ModeNormal Skyshot ModeDigital Skyshot Mode NonePlaten Manual Skyshot ModeCopy Combined Function TableOriginal SortInput Identification Code Using Function Modes to Change the Initial Copy ModesFunction OptionsGeneral Functions Modes Function Initial SettingModes Function Copier SettingsGeneral Functions for Key Operator Copier Settings for Key Operator Press the Function Key Proceed as Follows Function SettingChanging the Auto Exposure Setting B5R Function Setting for Key OperatorChanging the Paper Size Stopper Guide a Paper Guide b PaperFunctions Departmental CounterSelect the Department Counter Mode Components Accessories$2 in 1 Copy Automatic Document FeederADF DA-AS180 # Automatic Original FeedingInappropriate originals Place OriginalSheet Paper Tray Problem SolvingAdding Paper J Cap Adding the Toner and Replacing Toner Waste Container ?Problem Solving Paper Misfeed Locations Removing a Misfed PaperPaper Exit Area Surface Paper Entry/Transport AreaHot HeatedPaper Feed Module ADF Unit Does Not Operate TroubleshootingBefore Calling Service Check ActionMarked Copies Light CopiesGlass User Error Codes U CodeCode Display Message Check Points CoverDP-1810P Copier Specifications2nd Paper Feed Module DA-DS182 SpecificationsPart Name Remarks Options and SuppliesFor Printer SuppliesPage Page Warranty