ACCO Brands RDS 2270 Operation, Reverse Function, CD and Credit Card Shredding, Bin Full

Page 5

Operation

1Connect shredder to mains supply

2Press the central power on button (d). This will switch the power on and all the LED warning symbols on the indicator panel (a) will flash in sequence. The shredder will now be in standby mode and the “Power- on” symbol on the indicator panel will be illuminated amber.

3To commence shredding, press the right hand auto feed button (e) this will illuminate the feed area green and illuminate the symbol green.

This sets the shredder into auto mode and initiates the Mercury anti jam mechanism. You are now able to shred.

G

4Insert paper to be shredded into the feed area. The Mercury anti jam mechanism will sense the thickness of the paper being shredded.

If the paper thickness is within the shredders capacity the motor will start and your documents will be shredded. Cutters will stop once the shredding process is complete.

If the paper thickness is greater than the shredders sheet capacity the area around the feed slot will turn from green to red and the motor will not run. In this situation the Mercury Icon on the indicator panel will flash red, the green will go off, instead the will be illuminated red.

5If this happens, remove some of the sheets from the paper stack and re-try until the feed area reverts back to green, the shredder will then automatically start and allow the paper to be shredded.

If the shredder is left in auto mode for more than 10 minutes without being used, the shredder will automatically turn back to standby mode in order to save power.

Reverse Function

1Should you wish to reverse the shredding direction whilst shredding a document, a reverse button (f) has been fitted for your convenience.

2By pressing the reverse button the shredding cutters will change direction allowing the retrieval of the document being shredded. The feed area will turn to red.

3The reverse function will only run whilst the button is being pressed. When the reverse button has been released the shredder will revert to stand by mode.

4To turn back to auto mode simply press the right hand auto feed button again.

CD and Credit Card Shredding

The Mercury models can also shred CDs and credit cards.

1Pull up the orange CD guide (g) located in the centre of the feed area and flip it into position over the shredder mouth.

2For credit card shredding, switch the shredder to auto mode and insert the card into the centre slot.

3For CD shredding, extend the sides of the orange CD guide, switch the shredder to auto mode and place the CD into the centre of the CD slot.

Only 1 CD can be shred at a time.

Rare Occasions of Jamming

In the unlikely event of the shredder jamming, use the reverse function to unblock the shredder. (see Reverse function section)

Alternating between the reverse function and the forward run (Hold Auto start for 2 seconds) will help unblock the feed area.

Once the jam is clear, press the right hand auto button once to revert back to auto mode. You can now resume shredding as normal.

Bin Full

When the bin is full the shredder will not function and the bin full symbol will illuminate and flash red, the green will switch off and the will illuminate red.

When this happens you must empty the bin.

•Pull open the drawer to empty. (RSX1530, RSS1830, RSS2230 )

•Open the door to locate the bin (RDS2050, RDX1750, RDS2270 RDX1970)

Once the bin is empty, close the door/drawer and press the auto button to resume shredding.

Door Open Safety Function

If the door is opened during shredding as a safety precaution the shredder will instantly stop, and the door open symbol on the indicator panel will flash red. The green will go off and the red flash will illuminate. To resume shredding, shut the door and press the auto button.

Over Heating

If the shredder is used continuously for long periods of time the shredder may overheat. If this occurs the egg timer symbol on the indicator panel will flash amber, the green will go off and you will see the red .

When the shredder is ready to be used again the egg timer symbol will stop flashing and the green will show once again. To resume shredding press the auto button.

Shredder Waste Sacks

Rexel shredder waste sacks AS1000 (Code 40070) should be used with models RDS2050, RDX1750, RDS2270, RDX1970. We recommend that no waste sacks are to be used for the models RSX1530, RSS1830, RSS2230.



Page 4 Page 6
Image 5
Page 4 Page 6
Contents Mercury Models RSX1530 RSS1830 RSS2230 SpecificationsDuty Cycle Volts / HzPage Warranty Safety FirstLights and Icons Explained IntroductionOperation Door Open Safety FunctionReverse Function CD and Credit Card ShreddingConsignes de sécurité Explication des voyants et icônesTechnologie antibourrage Mercury GarantieFonction marche arrière FonctionnementDestruction de CD et de cartes de crédit Rares occasions de bourrageEinführung Erläuterung der Leuchtanzeigen und SymboleSicherheitshinweise m Mercury Anti-Stau-TechnologieRückwärtsbetriebsfunktion BetriebVernichten von CDs und Kreditkarten Vorgehen im seltenen Fall eines PapierstausIntroduzione Spiegazione delle spie e delle iconeLa sicurezza al primo posto Tecnologia antinceppamento MercuryFunzionamento in reverse FunzionamentoDistruzione di CD e carte di credito Casi rari di inceppamentoInleiding Uitleg over lichtjes en iconenVeiligheid voorop De antiblokkeringstechnologieTerugloopfunctie BedieningCd’s en creditcards versnipperen Mocht het papier ooit geblokkeerd rakenIntroducción Explicación de luces e iconosLa seguridad es lo primero Tecnología antiatascos MercuryFunción de retroceso FuncionamientoDestrucción de CDs y de tarjetas de crédito Ocasiones excepcionales de atascoIntrodução Explicação do Significado das Luzes e ÍconesSegurança em Primeiro Lugar m Tecnologia Anti-encravamento MercuryFunção Inverter FuncionamentoDestruição de CDs e de Cartões de Crédito Casos raros de encravamentoGiriş Işık ve Simgelerin AçıklamasıÖnce Güvenlik GarantiGeriye Çalıştırma ÇalıştırmaCD ve Kredi Kartlarının İmha Edilmesi Ender olarak kağıt sıkışmasıyla karşılaşıldığındaΕισαγωγή Επεξηγήσεις για τα φωτάκια και τις ενδείξειςΠρώτα η ασφάλεια Τεχνολογία αποφυγής εμπλοκής MercuryΑντίστροφη κίνηση ΛειτουργίαΚαταστροφή CD και πιστωτικών καρτών Σπάνιες περιπτώσεις εμπλοκήςIndledning Forklaring af lys og ikonerSikkerheden i første række Mercurys anti-papirstopteknologiReturfunktion BetjeningMakulering af cd’er og kreditkort Sjældne papirstopJohdanto Valojen ja kuvakkeiden merkityksetTurvallisuus ensin Mercuryn tukoksenestotekniikkaPeruutustoiminto ToimintaCD-levyjen ja luottokorttien silppuaminen Tukoksen sattuessaInnledning Forklaring av lys og ikonerSikkerhetm Mercury stoppsperreteknologiMakulere CD-er og kredittkort ReversfunksjonPapirstopp Full kurvInledning Förklaring av lamporna och ikonernaSäkerhetenm Mercurys mekanism mot fastkörningBackningsfunktionen AnvändningRivning av cd-skivor och kreditkort Exceptionell fastkörningWstęp Objaśnienia kontrolek i ikonekBezpieczeństwom GwarancjaFunkcja cofania Obsługa niszczarkiNiszczenie płyt CD i kart kredytowych Rzadkie przypadki zakleszczenia się papieruÚvod Vysvětlivky ke světlům a symbolůmBezpečnost především Protiucpávací čidlo MercuryZpětný chod ProvozSkartování CDček a kreditních karet Vzácný případ ucpáníBevezetés Fényjelek és ikonok magyarázataElső a biztonság Mercury elakadásgátló teechnológiaVisszamenet funkció ÜzemeltetésCD-k és hitelkártyák aprítása Esetleges elakadás megszüntetéseВведение Объяснение значения световых сигналов и символовБезопасность прежде всего m Технология предотвращения заедания бумаги MercuryФункция реверса ЭксплуатацияРезка компакт-дисков и кредитных карт Редких случаях заедания бумагиService
Top Page Image Contents