Sony CPD-17SF2T, CPD-15SF2T manual Owner’s Record

Page 2

Owner’s Record

The model and serial numbers are located at the rear of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your dealer regarding this product.

Model No. CPD-

 

Serial No.

WARNING

To prevent fire or shock hazard, do not expose the unit to rain or moisture. Dangerously high voltages are present inside the set. Do not open the cabinet. Refer servicing to qualified personnel only.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

INFORMATION

This product complies with Swedish National Council for Metrology (MPR) standards issued in December 1990 (MPR II) for very low frequency (VLF) and extremely low frequency (ELF).

INFORMATION

Ce produit est conforme aux normes du Swedish National Council for Metrology de décembre 1990 (MPR II) en ce qui concerne les fréquences très basses (VLF) et extrêmement basses (ELF).

Hinweis

Dieses Gerät erfüllt bezüglich tieffrequenter (very low frequency) und tiefstfrequenter (extremely low frequency) Strahlung die Vorschriften des „Swedish National Council for Metrology (MPR)“ vom Dezember 1990 (MPR II).

INFORMACIÓN

Este producto cumple las normas del Consejo Nacional Sueco para Metrología (MPR) emitidas en diciembre de 1990 (MPR II) para frecuencias muy bajas (VLF) y frecuencias extremadamente bajas (ELF).

(Only for CPD-15SF2T) Bescheinigung des Herstellers

Hiermit wird bescheinigt, daß der Monitor CPD-15SF2T in Übereinstimmung mit den Bestimmungen der BMPT- Amtsblatt Vfg 243/1991, Vfg 46/1992 funkentstört ist. Der vorschriftsmäßige Betrieb mancher Geräte (z.B. Meßsender) kann allerdings gewissen Einschränkungen unterliegen. Beachten Sie deshalb die Hinweise in der Bedienungsanleitung. Dem Bundesamt für Zulassungen in der Telekommunikation wurde das Inverkehrbringen dieses Gerätes angezeigt und die Berechtigung zur Überprüfung der Serie auf Einhaltung der Bestimmungen eingeräumt.

Sony Deutschland GmbH

Hugo Eckener Str. 20 50829 Köln

Hinweis

Gemäß der Amtsblätter des BMPT Nrn. 61/1991 und 6/1992 wird der Betreiber darauf aufmerksam gemacht, daß die von ihm mit diesem Gerät zusammengestellte Anlage auch den technischen Bestimmungen dieser Amtsblätter genügen muß.

Hinweise

Aus ergonomischen Gründen wird empfohlen, die Grundfarbe Blau nicht auf dunklem Untergrund zu verwenden (schlechte Erkennbarkeit, Augenbelastung bei zu geringem Zeichenkontrast).

Aus ergonomischen Gründen flimmern sollten nur Darstellungen bei Vertikalfrequenzen ab 70 Hz (ohne Zeilensprung) benutzt werden.

NOTICE

This notice is applicable for USA/Canada only.

If shipped to USA/Canada, install only a UL LISTED/CSA LABELLED power supply cord meeting the following specifications:

SPECIFICATIONS

Plug Type

Nema-Plug 5-15p

Cord

Type SVT or SJT, minimum 3 × 18

 

AWG

Length

Maximum 15 feet

Rating

Minimum 7 A, 125 V

NOTICE

Cette notice s’applique aux Etats-Unis et au Canada uniquement.

Si cet appareil est exporté aux Etats-Unis ou au Canada, utiliser le cordon d’alimentation portant la mention UL LISTED/CSA LABELLED et remplissant les conditions suivantes:

SPECIFICATIONS

Type de fiche

Fiche Nema 5-15 broches

Cordon

Type SVT ou SJT, minimum 3 × 18

 

 

 

 

 

 

AWG

Longueur

Maximum 15 pieds

Tension

Minimum 7 A, 125 V

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This monitor complies with the TCO 1992 guidelines for power saving when used with a computer equipped with VESA Display Power Management Signaling (DPMS).

2

Image 2 Contents
Multiscan15sf II Multiscan17sf Owner’s Record Introduction Table of ContentsPrecautions Getting Started Using Your MonitorPreset and User Modes Adjustments Adjusting the Picture ContrastAdjusting the Pincushion AdjustmentsAdjusting the Picture Size Adjusting the Picture RotationResetting Power Saving FunctionSetteing the color temperature Entering New TimingsPlug and Play Damper WireSpecifications Use of the Tilt-SwivelTroubleshooting Précautions InstallationEntretienTable des matières Pour les clients aux Etats-UnisModes par défaut et utilisateur PréparationUtilisation de votre moniteur Réglage du contraste de l’image RéglagesRéglage du centrage de l’image Réglage de la distorsion en coussin Réglage de la taille de l’imageRéglage de la rotation de l’image Réglages Réglage de la température des couleurs Introduction de nouvelles synchronisationsEconomies d’énergie RéinitialisationFil d’amortissement Un moniteur prêt à l’emploiUtilisation du support pivotant SpécificationsDépannage Einführung Installation WartungInhalt SicherheitsmaßnahmenVoreinstellungen und Benutzereinstellungen VorbereitungenArbeiten mit dem Monitor Einstellen des Bildkontrasts AnpassungenEinstellen der Bildhelligkeit Bildzentrierung Einstellen der Bildrotation Anpassungen Einstellen der BildgrößeKorrigieren der Kissenverzeichnung Einstellen der Farbtemperatur Eingeben neuer EinstellungenEnergiesparfunktion Zurücksetzen des GerätsDämpfungsdraht Plug and Play Technische DatenSchwenk-/ Neigevorrichtung Fehlerbehebung Precauciones IndiceIntroducción InstalaciónMantenimientoModos predefinidos y de usuario Procedimientos InicialesUso del monitor Ajuste del contraste de la imagen AjustesAjuste del brillo de la imagen Ajuste de la posición de centrado de la imagenAjuste de la rotación de la imagen Ajustes Ajuste del tamaño de la imagenAjuste de la distorsión de imagen Ajuste de la temperatura del color Introducción de nue vos valoresFunción de ahorro de energía Restauración de valoresHilos de amortiguación Función Plug and PlaySoporte basculante giratorio EspecificacionesSolución de problemas Precauzioni InstallazioneManutenzioneIntroduzione Avvertenza sui collegamenti per l’alimentazioneCondizioni di sincronizzazione orizzontale raccomandate Per iniziareModi preimpostati e modi utente Regolazioni Regolazione del contrasto dell’immagineRegolazioni Regolazione della dimensione dell’immagine Impostazione della temperatura di colore Nuove sincronizzazioniFunzione di risparmio energetico RipristinoCavi di smorzamento Uso immediato del monitorUso del sistema di orientamento SpecificheSoluzione dei problemi