3Com CS/2500 manual Maintenance

Maintenance 5-3

2Pry the cartridge loose. It should pop out easily.

3Slide the fuseholder cartridge completely out of the enclosure.

(Prying cartridge)

Figure 5-1 Removing the Fuseholder Cartridge

4Remove the fuse clip insert from the fuseholder cartridge.

The fuse clips, conductors, and fuses are mounted on this cartridge. Pull up the plastic retainer on the fuseholder cartridge and slide the insert away from the cartridge, as shown in in Figure 5-2.

5Once the fuse clip insert is clear of the fuseholder cartridge, pry the spent fuse from the fuse clip with the screwdriver.

6Replace the old fuse with a new fuse of the same type, size, and rating. Use a 2-A, 250-V fast-blow fuse (5 mm by 20 mm).

WARNING: For continued protection against fire hazard, replace the fuse only with a fuse having the same type and rating.

ATTENTION: Pour éviter le risque d’incendie, ne remplacer que par des fusibles de même type et valeur de courant.

7Reinstall the fuse clip insert in the cartridge so that the plastic retainer locks it in place.