Firmware Update
Table 17 Firmware Update
Command
Description
SET LOAd | Sets the firmware to perform a soft reset and enter the server boot program after the | |
ENable | next Exit command. |
|
| This command is used for diagnostic purposes only. | |
| The default value is Disable. |
|
| Format: |
|
| SET LOAd (ENable DIsable ] | |
SET LOAd HOst | Sets the node name of the TFTP boot host. | |
| This command is used for diagnostic purposes only. | |
| The default value is null>\ |
|
| Format: |
|
| SET LOAd HOst | <name> |
SET LOAd IP | Sets source computer IP address for TFTP get operation. | |
| The default value is 0.0.0.0. |
|
| Format: |
|
| SET LOAd IP aa.bb.cc.dd | |
SET LOAd | Sets filename on host for TFTP get update | |
SOftware | Format: |
|
|
| |
| SET LOAd SOftware | <filename> |
SET LOAd TFTP | Initiates firmware update using TFTP get operation. | |
| The TFTP server address must be set using SET LOAd IP and the filename using | |
| SET LOAd SOftware. The server will reset after the firmware update is completed. | |
| Format: |
|
| SET LOAd TFTP |
|
SET LOAd | Initiates firmware update using the XModem protocol on the serial console | |
XModem | The server will reset after the firmware update is completed. | |
| ||
| Format: |
|
| SET LOAd XModem |
|
SH LOAd | Shows the firmware update parameters | |
| Sample output: |
|
Firmware load is disabled
Load Host IP = 0.0.0.0
Software file = xxxx.bin
Load Host Name =
Console Commands | Silex | Page 57 |
| Part Number |
|