Packard Bell C3 Removing the LCD Panel, Removing the rubber covers & screws on the LCD Module

Page 12

Removing the LCD Panel

To remove the LCD panel, first remove the LCD module (see Removing the LCD Module), then perform the following steps:

1.Use a pin to remove the rubber covers on the LCD module as shown in Fig. 15

2.Unscrew all screws as shown in Fig. 15 and release carefully the LCD cover.

Fig. 15 Removing the rubber covers & screws on the LCD Module

3.Remove the inverter board after unscrewing the screw and disconnecting all connectors as shown in Fig. 16 .

Fig. 16 Removing the Inverter Board

4.Carefully lift up the LCD panel.

5.Remove the screws on both sides of the LCD panel in order to release the LCD hinges as shown in Fig. 17

Packard Bell EasyNote C3 Disassembly Manual

A=M2.5x5 silver

B=M2.5x6 black

M2x3 copper

12

Image 12
Contents Packard Bell EasyNote C3 Disassembly Manual Table of contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesPower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge Removing the Battery Removing the Memory ModuleRemoving the Hard Disk Drive Removing the memory moduleScrews retaining the HDD assembly Removing the KeyboardDisconnecting the keyboard flat cable Removing the Optical Disk Drive Releasing the optical disk driveRemoving the LCD Module Removing the screws retaining the Heat PlateM2.5x7 silver Removing the LCD Panel Removing the rubber covers & screws on the LCD ModuleRemoving the CPU Removing the LCD Panel hingesUnlocking the CPU Removing the Top Cover Bottom cover screws=M2.5x9 silver =M2.5x7 silver Removing the Touch Pad Removing the Main BoardM2x4 silver Removing the MDC Modem Lifting up carefully the main boardRemoving the Speaker Assembly DIP Switch SettingsDip Switches settings ScrewsEasyNote C3 Disassembly Manual