Packard Bell C3 manual Removing the Speaker Assembly, DIP Switch Settings

Page 20

Removing the Speaker Assembly

To remove the Speaker Assembly, first remove the Main Board (see Removing the Main Board) then perform the following steps:

1. Remove the screws holding the Speaker Assembly as shown in Fig. 31

Fig. 31 Speaker Assembly

2. Carefully remove the Speaker assembly from the bottom cover and place it aside.

DIP Switch Settings

Fig. 32 Dip Switches location

M2x6.5

Packard Bell EasyNote C3 Disassembly Manual

20

Image 20

Contents Packard Bell EasyNote C3 Disassembly Manual Table of contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage Removing the Battery Removing the Memory ModuleRemoving the Hard Disk Drive Removing the memory moduleScrews retaining the HDD assembly Removing the KeyboardDisconnecting the keyboard flat cable Removing the Optical Disk Drive Releasing the optical disk driveRemoving the LCD Module Removing the screws retaining the Heat PlateM2.5x7 silver Removing the LCD Panel Removing the rubber covers & screws on the LCD ModuleRemoving the CPU Removing the LCD Panel hingesUnlocking the CPU Removing the Top Cover Bottom cover screws=M2.5x9 silver =M2.5x7 silver Removing the Touch Pad Removing the Main BoardM2x4 silver Removing the MDC Modem Lifting up carefully the main boardRemoving the Speaker Assembly DIP Switch SettingsDip Switches settings ScrewsEasyNote C3 Disassembly Manual