Packard Bell C3 manual Removing the Keyboard, Screws retaining the HDD assembly

Page 7

Fig. 5 Screws retaining the HDD assembly

Removing the Keyboard

To remove the Keyboard, first remove the battery (see Removing the Battery), then perform the following steps:

1. Release the keyboard cover from the rear of the system as shown in Fig. 6

Fig. 6 Releasing the keyboard cover

2. Lift up the keyboard cover carefully as shown in Fig. 7

Fig. 7 Lifting up the keyboard cover

Packard Bell EasyNote C3 Disassembly Manual

M3x6 silver

7

Image 7

Contents Packard Bell EasyNote C3 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Memory Module Removing the BatteryRemoving the memory module Removing the Hard Disk DriveRemoving the Keyboard Screws retaining the HDD assemblyDisconnecting the keyboard flat cable Releasing the optical disk drive Removing the Optical Disk DriveRemoving the screws retaining the Heat Plate Removing the LCD ModuleM2.5x7 silver Removing the rubber covers & screws on the LCD Module Removing the LCD PanelRemoving the LCD Panel hinges Removing the CPUUnlocking the CPU Bottom cover screws Removing the Top Cover=M2.5x9 silver =M2.5x7 silver Removing the Main Board Removing the Touch PadM2x4 silver Lifting up carefully the main board Removing the MDC ModemDIP Switch Settings Removing the Speaker AssemblyScrews Dip Switches settingsEasyNote C3 Disassembly Manual