Packard Bell C3 manual Removing the MDC Modem, Lifting up carefully the main board

Page 19

4. Lift up the Main Board as shown in Fig. 29 and put it aside.

Fig. 29 Lifting up carefully the main board

Removing the MDC Modem

To remove the MDC Modem, first remove the Main Board (see Removing the Main Board) then perform the following steps:

1.Disconnect the MDC cable and remove the two screws retaining the MDC modem as shown in Fig. 30

Fig. 30 The MDC Modem

2. Lift up the MDC modem and put it aside.

Packard Bell EasyNote C3 Disassembly Manual

M2x4 silver

19

Image 19

Contents Packard Bell EasyNote C3 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Memory Module Removing the BatteryRemoving the memory module Removing the Hard Disk DriveRemoving the Keyboard Screws retaining the HDD assemblyDisconnecting the keyboard flat cable Releasing the optical disk drive Removing the Optical Disk DriveRemoving the screws retaining the Heat Plate Removing the LCD ModuleM2.5x7 silver Removing the rubber covers & screws on the LCD Module Removing the LCD PanelRemoving the LCD Panel hinges Removing the CPUUnlocking the CPU Bottom cover screws Removing the Top Cover=M2.5x9 silver =M2.5x7 silver Removing the Main Board Removing the Touch PadM2x4 silver Lifting up carefully the main board Removing the MDC ModemDIP Switch Settings Removing the Speaker AssemblyScrews Dip Switches settingsEasyNote C3 Disassembly Manual