Packard Bell C3 manual Removing the LCD Module, Removing the screws retaining the Heat Plate

Page 10

Removing the LCD Module

To remove the LCD Module first remove the battery (see Removing the Battery) and remove the keyboard (see Removing the Keyboard), then perform the following steps:

1. Remove the screws retaining the Heat Plate as shown in Fig. 11

Fig. 11 Removing the screws retaining the Heat Plate

2. Flip over the base unit and release the screws retaining the LCD Module.

Fig. 12 Bottom screws retaining the LCD Module

3.Release the screws on the system rear side as shown in Fig. 13

Fig. 13 Rear screws retaining the LCD Module

M2.5x7 silver

M2.5x9 silver

M2.5x9 silver

Packard Bell EasyNote C3 Disassembly Manual

10

Image 10

Contents Packard Bell EasyNote C3 Disassembly Manual Table of contents Overview Disassembly InstructionsReassembly Instructions Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Battery Removing the Memory ModuleRemoving the Hard Disk Drive Removing the memory moduleScrews retaining the HDD assembly Removing the KeyboardDisconnecting the keyboard flat cable Removing the Optical Disk Drive Releasing the optical disk driveRemoving the LCD Module Removing the screws retaining the Heat PlateM2.5x7 silver Removing the LCD Panel Removing the rubber covers & screws on the LCD ModuleRemoving the CPU Removing the LCD Panel hingesUnlocking the CPU Removing the Top Cover Bottom cover screws=M2.5x9 silver =M2.5x7 silver Removing the Touch Pad Removing the Main BoardM2x4 silver Removing the MDC Modem Lifting up carefully the main boardRemoving the Speaker Assembly DIP Switch SettingsDip Switches settings ScrewsEasyNote C3 Disassembly Manual