Packard Bell C3 manual Removing the CPU, Removing the LCD Panel hinges

Page 13

Fig. 17 Removing the LCD Panel hinges

Removing the CPU

To remove the CPU first remove the battery (see Removing the Battery) and remove the Keyboard (see Removing the Keyboard), then perform the following steps:

1. Remove the screws retaining the Heat Plate as shown in Fig. 18

Fig. 18 Removing the screws retaining Heat Plate

2.After taking out the heat plate, remove the CPU Fan screws, disconnect the CPU Fan connector and remove the CPU Fan as shown in Fig. 19

Fig. 19 The CPU Fan

M2x3 copper

M2.5x7 silver

M2.5x7 silver

Packard Bell EasyNote C3 Disassembly Manual

13

Image 13

Contents Packard Bell EasyNote C3 Disassembly Manual Table of contents Reassembly Instructions Disassembly InstructionsOverview Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Memory Module Removing the BatteryRemoving the memory module Removing the Hard Disk DriveRemoving the Keyboard Screws retaining the HDD assemblyDisconnecting the keyboard flat cable Releasing the optical disk drive Removing the Optical Disk DriveRemoving the screws retaining the Heat Plate Removing the LCD ModuleM2.5x7 silver Removing the rubber covers & screws on the LCD Module Removing the LCD PanelRemoving the LCD Panel hinges Removing the CPUUnlocking the CPU Bottom cover screws Removing the Top Cover=M2.5x9 silver =M2.5x7 silver Removing the Main Board Removing the Touch PadM2x4 silver Lifting up carefully the main board Removing the MDC ModemDIP Switch Settings Removing the Speaker AssemblyScrews Dip Switches settingsEasyNote C3 Disassembly Manual