Packard Bell C3 manual Removing the Top Cover, Bottom cover screws

Page 15

Note: Use extra care when unlocking or locking the CPU because the screw driver might cause damage on CPU’s edge each time when unlocking or locking the CPU.

Removing the Top Cover

To remove the Top Cover , first remove the battery (see Removing the Battery), remove the HDD (see Removing the Hard Disk Drive), remove the optical disk drive (see Removing the Optical Disk Drive), remove the keyboard (see Removing the Keyboard) and remove the LCD module (see Removing the LCD Module) then perform the following steps:

1. Remove all screws on the bottom of the base unit as shown in Fig. 22

Fig. 22 Bottom cover screws

M2.5x9 silver

Packard Bell EasyNote C3 Disassembly Manual

15

Image 15

Contents Packard Bell EasyNote C3 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewPower Supply Unit Hazardous VoltageAvoid Electrostatic Discharge Removing the Memory Module Removing the BatteryRemoving the memory module Removing the Hard Disk DriveRemoving the Keyboard Screws retaining the HDD assemblyDisconnecting the keyboard flat cable Releasing the optical disk drive Removing the Optical Disk DriveRemoving the screws retaining the Heat Plate Removing the LCD ModuleM2.5x7 silver Removing the rubber covers & screws on the LCD Module Removing the LCD PanelRemoving the LCD Panel hinges Removing the CPUUnlocking the CPU Bottom cover screws Removing the Top Cover=M2.5x9 silver =M2.5x7 silver Removing the Main Board Removing the Touch PadM2x4 silver Lifting up carefully the main board Removing the MDC ModemDIP Switch Settings Removing the Speaker AssemblyScrews Dip Switches settingsEasyNote C3 Disassembly Manual