Programming the Scanner
User Defined Code ID
This section allows the user to define and program a Code ID that is different from the Code ID default.
To specify a one-character Code ID, scan in the 2-digit hex value for that character. Then scan “END.” The hex value can be determined by referring to the HEX/ASCII Reference Table on page A-6.
To specify a two-character Code ID, scan the 2-digit hex values for each of the desired characters. Then scan “END.” If you only want to assign a one-character Code ID for UPC-E or EAN-8, scan the two-digit hex code for the desired character. Then Scan “FIN” and “END” bar codes.
Note: To transmit the Code ID, you have to enable Code ID transmission on page 3-12.