Hand Held Products 3060, 3220, 3080 manual Ascii Input Shortcut, Example, HEX/ASCII Reference Table

Appendix A

ASCII Input Shortcut

To configure the user definable parameters of the scanner via the programming bar codes, you will be asked to scan your desired ASCII value in HEX form. You have to refer to the “HEX/ASCII Table” for details.

Example:

If you want the scanned data output leading with a Dollar Sign, you have to set the “Preamble” to “$.” The configuration procedure is listed below for reference.

Scan the system command – PROGRAM listed on page 3-22 to enter programming mode.

Scan family code – PREAMBLE to select this family.

In the Hex/ASCII Table, you will find the HEX value of “$” is 24.

Scan the option code – 2 listed on the foldout back cover. Scan the option code – 4 listed on the foldout back cover. Scan the system command – FIN (Finish) to terminate Preamble setting.

Scan the system command – End to exit the programming mode for normal operation.

HEX/ASCII Reference Table

	0	1	2	3	4	5	6	7
0	NUL	DLE	SPACE	0	@	P	`	p
1	SOH	DC1	!	1	A	Q	a	q
2	STX	DC2	"	2	B	R	b	r
3	ETX	DC3	#	3	C	S	c	s
4	EOT	DC4	$	4	D	T	d	t
5	ENQ	NAK	%	5	E	U	e	u
6	ACK	SYN	&	6	F	V	f	v
7	BEL	ETB	'	7	G	W	g	w
8	BS	CAN	(	8	H	X	h	x
9	HT	EM	)	9	I	Y	i	y
A	LF	SUB	*	:	J	Z	j	z
B	VT	ESC	+	;	K	[	k	{
C	FF	FS	,	<	L	\	l
D	CR	GS	-	=	M	]	m	}
E	SO	RS	.	>	N	^	n	~
F	SI	US	/	?	O	_	o	DEL

Example : ASCII “A” → HEX “41;” ASCII “a” → “61” : High Byte of HEX Value

: Low Byte of HEX Value

A-6