Hand Held Products 3080, 3060, 3220 manual Data Formatter

Programming the Scanner

Condensed Data Editor

♦ Data Formatter ♦

PROGRAM			END(Exit)
Family Code Selection	Parameter Selection	Option Code	2nd Option Code
Formatter Control	Disable	FIN
	Select one bar code symbology	(2 digits)	automatic termination
	Select all bar code symbologies	00	automatic termination
1st Insertion	Disable	FIN	Hex value for each
	Enable	(2 digits)	character, (FIN)
	2-digits identified position; max. 3 insertion characters	position	1-3 characters to insert
2nd Insertion	Disable	FIN	Hex value for each
	Enable	(2 digits)	character, (FIN)
	2-digits identified position; max. 3 insertion characters	position	1-3 characters to insert
3rd Insertion	Disable	FIN	Hex value for each
	Enable	(2 digits)	character, (FIN)
	2-digits identified position; max. 3 insertion characters	position	1-3 characters to insert
4th Insertion	Disable	FIN	Hex value for each
	Enable	(2 digits)	character, (FIN)
	2-digits identified position; max. 3 insertion characters	position	1-3 characters to insert

FACTORY DEFAULT

The Data Formatter is used to edit the scanned raw data prior to transmitting the data to the host computer or terminal. It allows you to select desired bar code symbologies for formatter control, and provides Multiple Position Insertion and Multiple Character Insertion (max three characters) in the identified position.

If the Data Formatter is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbolology ID or Record Suffix. All of the above programmable parameters perform the same function depending on your setting.

Please refer to page 3-37 for information about the “Bar Code Selection” and “Position Calculation” of the data formatter. To determine the hex value for the “Character,” refer to the HEX/ASCII Table on page A-6

Refer to page 3-12 for for the 2-digit symbology option code.

3-33