Hand Held Products 3060, 3220, 3080 manual Data Verifier Settings

Programming the Scanner

Condensed Data Editor

♦ Data Verifier Settings ♦

PROGRAM				END(Exit)
Family Code Selection	Parameter Selection		Option Code	2nd Option Code
Verifier Control	Disable		FIN
	Select one bar code symbology		(2 digits)	automatic termination
	Select all bar code symbologies	00		automatic termination
Identified Data Length	Disable		FIN
	Enable		(2-digit decimal
			value)
	Determine the identified data length for verification.
1st Identified Character	Disable		FIN
	Enable		(2-digit HEX	[00-7F]
			value)
	2-digits checking position; 1 identified character		position
2nd Identified Character	Disable		FIN
	Enable		(2-digit HEX	[00-7F]
			value)
	2-digits checking position; 1 identified character		position
3rd Identified Character	Disable		FIN
	Enable		(2-digit HEX	[00-7F]
			value)
	2-digits checking position; 1 identified character		position

The Data Verifier is used to provide advanced verification for error-free scanning and to work as an Embedded Data Transmitting Filter.

All data must conform to the Identified Bar Code Symbologies, Identified Data Length, and one to three Identified Characters in the checking position. Otherwise, the scanner will not transmit the data to the host computers, but will instead issue 3 long beeps for verification error and skip the scanned data.

The Data Verifier checks only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID, or Record Suffix. Please refer to page 3-37 for information about the “Bar Code Selection” and “Position Calculation” of Data Verifier.

To determine the hex value for the “Character,” refer to the HEX/ASCII Table on page A-6. Refer to page 3-12 for 2-digit symbology option code.

3-34