Dell BMX01 owner manual Module Port Mapping-Full-Height Blades, Quarter-Height Blades

Fabric A	Fabric B Mezzanine	Fabric C Mezzanine	I/O Bay A1, A2	I/O Bay B1, B2	I/O Bay C1, C2
	Card	Card
			or pass-
			through
			module
Standard	Infiniband mezzanine	Ethernet mezzanine	Ethernet	Infiniband	Ethernet switch
Integrated LOM	card	card	switch module	switch module	module or
			or pass-		pass-through
			through		module
			module
Standard	Fibre channel	Ethernet mezzanine	Ethernet	Fibre channel	Ethernet switch
Integrated LOM	mezzanine card	card	switch module	switch or	module or
			or pass-	pass-through	pass-through
			through	module	module
			module

Quarter-Height Blades

A quarter-height blade supports one mezzanine card. The mezzanine card slot supports Fabric B or Fabric C, depending on the slot in the sleeve where the blade is installed.

I/O Module Port Mapping—Full-Height Blades

NOTE: The I/O port mappings in the following sections are applicable only to the I/O Pass-Through Modules.

Standard LOM (Dual-Port) Mapping

Each LOM has two port connections. For a full-height blade in bay n:

•Integrated LOM1, connection 1 connects to I/O module A1, port n.

•Integrated LOM1, connection 2 connects to I/O module A2, port n.

•Integrated LOM2, connection 1 connects to I/O module A1, port n+8.

•Integrated LOM2, connection 2 connects to I/O module A2, port n+8.

For example, in a full-height blade in slot 5:

•Integrated LOM1 connection 1 connects to I/O module A1, port 5.

•Integrated LOM1 connection 2 connects to I/O module A2, port 5.

•Integrated LOM2 connection 1 connects to I/O module A1, port 13.

•Integrated LOM2 connection 2 connects to I/O module A2, port 13.

NOTE: Even though PowerEdge M610x is a full-height blade system, only one network controller (LOM1) is available.

For PowerEdge M610x blade in bay n, the integrated NIC connects to I/O module A1, port n and I/O module A2, port n.

Dual-Port Mezzanine Cards

Each mezzanine card has two port connections. For a full-height blade in bay n:

37