Dell I2200, I1200 manual Installing the Display Panel

Page 16

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the display assembly.

3.Remove the display bezel.

4.Remove the four M2 x 3-mm screws from each side of the display panel.

5.Lift the display panel out of the top cover.

6.Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.

1inverter connector

2pull-tab on bottom flex- cable connector

3top flex-cable connector

4display connector

7.Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.

Installing the Display Panel

1.Connect the top flex-cable connector to the display panel connector.

2.Connect the bottom flex-cable connector to the inverter connector.

3.Lay the display panel into the top cover.

4.Route the display-feed flex cable so that it rests in the notch located in the bottom edge of the top cover.

5.Replace the eight M2 x 3-mm screws that secure the display panel to the top cover.

6.Replace the display bezel.

Back to Contents Page

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Model PP10S June 2005 Rev. A01 Base Plastics Before You Begin Recommended ToolsTurning Off Your Computer Before Working Inside Your ComputerComputer Orientation Turn off your computerScrew Identification Back to Contents Flashing the Bios From a Floppy Disk or a CD Flashing the BiosFlashing the Bios From the Hard Drive Back to Contents Coin-Cell Battery Remove the display assembly Remove the Mini PCI cardMicroprocessor Module Removing the Microprocessor ModuleInstalling the Microprocessor Module Replace the microprocessor thermal-cooling assemblyDisplay Assembly DisplayPage Page Display Panel Display BezelRemoving the Display Panel Installing the Display Panel Hard Drive Installing the Hard DriveRemoving the Hard Drive Back to Contents Keyboard Removing the KeyboardInstalling the Keyboard Palm Rest Back to Contents USB Connector Pinout Assignments for I/O ConnectorsVideo Connector Speakers Removing the SpeakersInstalling the Speakers System Board Removing the System BoardPage Installing the System Board Replace the display assembly System Components Microprocessor Thermal-Cooling Assembly Removing the Cooling FanInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory Memory, Optical Drive, Modem, and Mini PCI CardRemoving the Memory Module Optical Drive Installing the Memory ModulesRemoving the Optical Drive Modem Installing the Optical DriveRemoving the Modem Page Mini PCI Card Installing the ModemRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents
Top Page Image Contents