Dell I1200, I2200 manual Removing the Microprocessor Thermal-Cooling Assembly

Page 33

.

1M2 x 3-mm screws (2)

2fan connector

3.Align the EMI shield retention tabs with the retention-tab slots on the computer base and rotate the front until it lies flat.

4.Replace the four M2.5 x 5-mm screws that secure it to the system board.

1M2.5 x 5-mm screws (4)

2shield retention tabs (3)

3shield-retention tab slots

1 M2.5 x 5-mm screws (4)

Removing the Microprocessor Thermal-Cooling Assembly

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

Image 33

Contents Model PP10S June 2005 Rev. A01 Base Plastics Recommended Tools Before You BeginTurning Off Your Computer Before Working Inside Your ComputerTurn off your computer Computer OrientationScrew Identification Back to Contents Flashing the Bios Flashing the Bios From a Floppy Disk or a CDFlashing the Bios From the Hard Drive Back to Contents Remove the display assembly Remove the Mini PCI card Coin-Cell BatteryRemoving the Microprocessor Module Microprocessor ModuleReplace the microprocessor thermal-cooling assembly Installing the Microprocessor ModuleDisplay Display AssemblyPage Page Display Bezel Display PanelRemoving the Display Panel Installing the Display Panel Installing the Hard Drive Hard DriveRemoving the Hard Drive Back to Contents Removing the Keyboard KeyboardInstalling the Keyboard Palm Rest Back to Contents Pinout Assignments for I/O Connectors USB ConnectorVideo Connector Removing the Speakers SpeakersInstalling the Speakers Removing the System Board System BoardPage Installing the System Board Replace the display assembly System Components Removing the Cooling Fan Microprocessor Thermal-Cooling AssemblyInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory, Optical Drive, Modem, and Mini PCI Card MemoryRemoving the Memory Module Installing the Memory Modules Optical DriveRemoving the Optical Drive Installing the Optical Drive ModemRemoving the Modem Page Installing the Modem Mini PCI CardRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents