Dell I1200, I2200 manual Microprocessor Thermal-Cooling Assembly, Removing the Cooling Fan

Page 31

Back to Contents Page

Microprocessor Thermal-Cooling Assembly

Dell™ Inspiron™ i1200 and i2200 Service Manual

Removing the Cooling Fan

Installing the Cooling Fan

Removing the Microprocessor Thermal-Cooling Assembly

Installing the Microprocessor Thermal-Cooling Assembly

Removing the Cooling Fan

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.

To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the keyboard.

3.Disconnect the display ground wire from the EMI shield by unscrewing the captive screw.

1captive screw

2display ground wire

4.Remove the four M2.5 x 5-mm screws (labeled "M2.5x5") that secure the EMI shield to the system board.

5.Pull the EMI shield out of the computer baseby rotating the front upwards then lifting to release the retention tabs from the retention-tab slots.

Image 31

Contents Model PP10S June 2005 Rev. A01 Base Plastics Before Working Inside Your Computer Before You BeginRecommended Tools Turning Off Your ComputerTurn off your computer Computer OrientationScrew Identification Back to Contents Flashing the Bios From a Floppy Disk or a CD Flashing the BiosFlashing the Bios From the Hard Drive Back to Contents Remove the display assembly Remove the Mini PCI card Coin-Cell BatteryRemoving the Microprocessor Module Microprocessor ModuleReplace the microprocessor thermal-cooling assembly Installing the Microprocessor ModuleDisplay Display AssemblyPage Page Display Panel Display BezelRemoving the Display Panel Installing the Display Panel Hard Drive Installing the Hard DriveRemoving the Hard Drive Back to Contents Removing the Keyboard KeyboardInstalling the Keyboard Palm Rest Back to Contents USB Connector Pinout Assignments for I/O ConnectorsVideo Connector Removing the Speakers SpeakersInstalling the Speakers Removing the System Board System BoardPage Installing the System Board Replace the display assembly System Components Removing the Cooling Fan Microprocessor Thermal-Cooling AssemblyInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory Memory, Optical Drive, Modem, and Mini PCI CardRemoving the Memory Module Optical Drive Installing the Memory ModulesRemoving the Optical Drive Modem Installing the Optical DriveRemoving the Modem Page Mini PCI Card Installing the ModemRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents