Dell I2200, I1200 manual Removing the Microprocessor Module

Page 10

Back to Contents Page

Microprocessor Module

Dell™ Inspiron™ i1200 and i2200 Service Manual

Removing the Microprocessor Module

Installing the Microprocessor Module

Removing the Microprocessor Module

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

NOTICE: Press and hold the microprocessor down by applying slight pressure to the center of the microprocessor while turning the cam screw to prevent intermittent contact between the cam screw and microprocessor.

NOTICE: To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the keyboard.

3.Remove the cooling fan.

4.Remove the microprocessor thermal-cooling assembly.

NOTICE: When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.

5.To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.

The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.

1ZIF-socket

2microprocessor module

3pin-1 corner of microprocessor

4ZIF-socket cam screw

6.Use a microprocessor extraction tool to remove the microprocessor module.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Model PP10S June 2005 Rev. A01 Base Plastics Turning Off Your Computer Before You BeginRecommended Tools Before Working Inside Your ComputerComputer Orientation Turn off your computerScrew Identification Back to Contents Flashing the Bios From a Floppy Disk or a CD Flashing the BiosFlashing the Bios From the Hard Drive Back to Contents Coin-Cell Battery Remove the display assembly Remove the Mini PCI cardMicroprocessor Module Removing the Microprocessor ModuleInstalling the Microprocessor Module Replace the microprocessor thermal-cooling assemblyDisplay Assembly DisplayPage Page Display Panel Display BezelRemoving the Display Panel Installing the Display Panel Hard Drive Installing the Hard DriveRemoving the Hard Drive Back to Contents Keyboard Removing the KeyboardInstalling the Keyboard Palm Rest Back to Contents USB Connector Pinout Assignments for I/O ConnectorsVideo Connector Speakers Removing the SpeakersInstalling the Speakers System Board Removing the System BoardPage Installing the System Board Replace the display assembly System Components Microprocessor Thermal-Cooling Assembly Removing the Cooling FanInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory Memory, Optical Drive, Modem, and Mini PCI CardRemoving the Memory Module Optical Drive Installing the Memory ModulesRemoving the Optical Drive Modem Installing the Optical DriveRemoving the Modem Page Mini PCI Card Installing the ModemRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents
Top Page Image Contents