Dell I2200, I1200 manual Display Assembly

Page 12

Back to Contents Page

Display

Dell™ Latitude™ 110L Service Manual

Display Assembly

Display Bezel

Display Panel

Display Assembly

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the keyboard.

3.Disconnect the display ground wire from the EMI shield by unscrewing the captive screw.

1captive screw

2display ground wire

4.Remove the four M2.5 x 5-mm screws (labeled "M2.5x5") that secure the EMI shield to the system board.

5.Pull the EMI shield out of the computer baseby rotating the front upwards then lifting to release the retention tabs from the retention-tab slots.

Image 12
Contents Model PP10S June 2005 Rev. A01 Base Plastics Before You Begin Recommended ToolsTurning Off Your Computer Before Working Inside Your ComputerComputer Orientation Turn off your computerScrew Identification Back to Contents Flashing the Bios Flashing the Bios From a Floppy Disk or a CDFlashing the Bios From the Hard Drive Back to Contents Coin-Cell Battery Remove the display assembly Remove the Mini PCI cardMicroprocessor Module Removing the Microprocessor ModuleInstalling the Microprocessor Module Replace the microprocessor thermal-cooling assemblyDisplay Assembly DisplayPage Page Display Bezel Display PanelRemoving the Display Panel Installing the Display Panel Installing the Hard Drive Hard DriveRemoving the Hard Drive Back to Contents Keyboard Removing the KeyboardInstalling the Keyboard Palm Rest Back to Contents Pinout Assignments for I/O Connectors USB ConnectorVideo Connector Speakers Removing the SpeakersInstalling the Speakers System Board Removing the System BoardPage Installing the System Board Replace the display assembly System Components Microprocessor Thermal-Cooling Assembly Removing the Cooling FanInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory, Optical Drive, Modem, and Mini PCI Card MemoryRemoving the Memory Module Installing the Memory Modules Optical DriveRemoving the Optical Drive Installing the Optical Drive ModemRemoving the Modem Page Installing the Modem Mini PCI CardRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents