Dell I2200, I1200 manual Computer Orientation, Turn off your computer

Page 4

NOTICE: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is not covered by your warranty.

NOTICE: When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the cable itself. Some cables have a connector with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.

NOTICE: To avoid damaging the computer, perform the following steps before you begin working inside the computer.

1.Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.

2.Turn off your computer.

3.If the computer is connected to a docking device, undock it. See the documentation that came with your docking device for instructions.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.

4.Disconnect any telephone, network, and USB cables from the computer.

5.Disconnect your computer and all attached devices from their electrical outlets.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

6.Remove any installed PC Cards from the PC Card slot.

7.Close the display and turn the computer upside down on a flat work surface.

NOTICE: To avoid damaging the system board, you must remove the main battery before you service the computer.

8.Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the battery bay.

1battery

2battery-bay latch release

Computer Orientation

Image 4
Contents Model PP10S June 2005 Rev. A01 Base Plastics Before You Begin Recommended ToolsTurning Off Your Computer Before Working Inside Your ComputerComputer Orientation Turn off your computerScrew Identification Back to Contents Flashing the Bios From a Floppy Disk or a CD Flashing the BiosFlashing the Bios From the Hard Drive Back to Contents Coin-Cell Battery Remove the display assembly Remove the Mini PCI cardMicroprocessor Module Removing the Microprocessor ModuleInstalling the Microprocessor Module Replace the microprocessor thermal-cooling assemblyDisplay Assembly DisplayPage Page Display Panel Display BezelRemoving the Display Panel Installing the Display Panel Hard Drive Installing the Hard DriveRemoving the Hard Drive Back to Contents Keyboard Removing the KeyboardInstalling the Keyboard Palm Rest Back to Contents USB Connector Pinout Assignments for I/O ConnectorsVideo Connector Speakers Removing the SpeakersInstalling the Speakers System Board Removing the System BoardPage Installing the System Board Replace the display assembly System Components Microprocessor Thermal-Cooling Assembly Removing the Cooling FanInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory Memory, Optical Drive, Modem, and Mini PCI CardRemoving the Memory Module Optical Drive Installing the Memory ModulesRemoving the Optical Drive Modem Installing the Optical DriveRemoving the Modem Page Mini PCI Card Installing the ModemRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents