Dell I2200, I1200 manual Removing the Speakers

Page 24

Back to Contents Page

Speakers

Dell™ Inspiron™ i1200 and i2200 Service Manual

Removing the Speakers

Installing the Speakers

Removing the Speakers

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

The speakers are located on the left and right corners of the front of the base plastics. Take note of the speaker cable routing so that you can replace the cables properly under or between their routing clips.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the hard drive.

3.Remove the optical drive.

4.Remove the keyboard.

5.Remove the display assembly.

6.Remove the palm rest.

7.Disconnect the speaker connector from the system board.

1left speaker

2M2.5 x 5-mm screws (4)

3speaker connector

4right speaker

NOTICE: Remove the speaker cables from their routing clips with care to avoid damaging the cables.

8.Remove the speaker cables from under or between their routing clips.

NOTICE: Handle the speakers with care to avoid damaging them.

9.Remove the four M2.5 x 5-mm screws from the speaker mounts.

10.Remove the speakers by pulling them straight up and out of the base plastics.

Image 24
Contents Model PP10S June 2005 Rev. A01 Base Plastics Before You Begin Recommended ToolsTurning Off Your Computer Before Working Inside Your ComputerComputer Orientation Turn off your computerScrew Identification Back to Contents Flashing the Bios Flashing the Bios From a Floppy Disk or a CDFlashing the Bios From the Hard Drive Back to Contents Coin-Cell Battery Remove the display assembly Remove the Mini PCI cardMicroprocessor Module Removing the Microprocessor ModuleInstalling the Microprocessor Module Replace the microprocessor thermal-cooling assemblyDisplay Assembly DisplayPage Page Display Bezel Display PanelRemoving the Display Panel Installing the Display Panel Installing the Hard Drive Hard DriveRemoving the Hard Drive Back to Contents Keyboard Removing the KeyboardInstalling the Keyboard Palm Rest Back to Contents Pinout Assignments for I/O Connectors USB ConnectorVideo Connector Speakers Removing the SpeakersInstalling the Speakers System Board Removing the System BoardPage Installing the System Board Replace the display assembly System Components Microprocessor Thermal-Cooling Assembly Removing the Cooling FanInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory, Optical Drive, Modem, and Mini PCI Card MemoryRemoving the Memory Module Installing the Memory Modules Optical DriveRemoving the Optical Drive Installing the Optical Drive ModemRemoving the Modem Page Installing the Modem Mini PCI CardRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents