Dell I1200, I2200 manual

Page 27

1

hex screws (2)

15.Disconnect the display switch connector from the system board.

1 display switch connector

16.Remove any cards from the PCMCIA slot.

17.Remove the two M2.5 x 5-mm system board screws and lift the front of the system board out and away from the base plastics.

Image 27

Contents Model PP10S June 2005 Rev. A01 Base Plastics Before Working Inside Your Computer Before You BeginRecommended Tools Turning Off Your ComputerTurn off your computer Computer OrientationScrew Identification Back to Contents Flashing the Bios Flashing the Bios From a Floppy Disk or a CDFlashing the Bios From the Hard Drive Back to Contents Remove the display assembly Remove the Mini PCI card Coin-Cell BatteryRemoving the Microprocessor Module Microprocessor ModuleReplace the microprocessor thermal-cooling assembly Installing the Microprocessor ModuleDisplay Display AssemblyPage Page Display Bezel Display PanelRemoving the Display Panel Installing the Display Panel Installing the Hard Drive Hard DriveRemoving the Hard Drive Back to Contents Removing the Keyboard KeyboardInstalling the Keyboard Palm Rest Back to Contents Pinout Assignments for I/O Connectors USB ConnectorVideo Connector Removing the Speakers SpeakersInstalling the Speakers Removing the System Board System BoardPage Installing the System Board Replace the display assembly System Components Removing the Cooling Fan Microprocessor Thermal-Cooling AssemblyInstalling the Cooling Fan Removing the Microprocessor Thermal-Cooling Assembly Page Installing the Microprocessor Thermal-Cooling Assembly Model PP10S June 2005 Rev. A01 Memory, Optical Drive, Modem, and Mini PCI Card MemoryRemoving the Memory Module Installing the Memory Modules Optical DriveRemoving the Optical Drive Installing the Optical Drive ModemRemoving the Modem Page Installing the Modem Mini PCI CardRemoving the Mini PCI Card Page Installing the Mini PCI Card Page Back to Contents